BLP55-1005 Datasheet, PDF (1/5 Pages) Power-One – three-output ac-dc power conversion to meet the requirements of networking and data communications systems,

BLP55 AC-DC Series Data Sheet
55 Watts
Features
• RoHS lead-free solder and lead-solder-exempted
products are available
• Industry-standard 3” x 5” footprint
• Main output remote sense
• CE marked to Low Voltage Directive
• Compliance to EN61000-4-2/-3/-4/-5/-6/-8
Description
The BLP55 Series’ economical and compact construction provides single or three-output ac-dc power conversion to
meet the requirements of networking and data communications systems, as well as commercial and industrial
configurations.
The BLP55 is rated for convection, as well as forced-air cooling. Full output power is available with external
forced-air cooling. Other features include main-output remote sense and an internal EMI filter.
Single Output Model Selection
MODEL
NOMINAL OUTPUT
MIN-MAXIMUM OUTPUT
BLP55-1005
VOLTAGE (VDC)
5V
CURRENT, CONVECTION
0 to 8A
BLP55-1012
12V
0 to 3.3A
BLP55-1024
24V
0 to 1.6A
MIN-MAXIMUM OUTPUT
CURRENT ¹
0 to 11A
0 to 4.5A
0 to 2.3A
Triple Output Model Selection
MODEL
NOMINAL OUTPUT
MIN-MAXIMUM OUTPUT
BLP55-3000
VOLTAGE (VDC)
+5V
+12V
-12V
CURRENT, CONVECTION
0.4 to 4A
0.2 to 2A
0.0 to 0.5A
BLP55-3300
+3.3V
+5V
+12V
0.5 to 4A
0.0 to 2A
0.0 to 0.5A
MIN-MAXIMUM OUTPUT
CURRENT ¹
0.5 to 5A
0.2 to 2.5A
0.0 to 0.7A
0.5 to 5A
0.0 to 2.5A
0.0 to 0.7A
PEAK OUTPUT
CURRENT ²
12A
5A
2.5A
PEAK OUTPUT
CURRENT ²
7A
4A
1
7A
4A
1A
TOTAL
REGULATION % ³
±2
±2
±2
TOTAL
REGULATION % ³
±2
±5
±5
±2.5
±2.5
±5
RIPPLE & NOISE
%p-p ⁴
1
1
1
RIPPLE & NOISE
%p-p ⁴
1
1
1
1
1
1
NOTES: ¹ 10 CFM or 150 LFM (average measurement of six equally-distanced points through a 3.5” x 1.6” cross-sectional area) with power supply mounted
on 0.25” standoffs. Recommended airflow direction is from the AC side to the DC side.
2 _{Peak current duration for less than 30 Sec with a maximum duty cycle of 10%.}
3 _{At 25 °C ambient including voltage set point tolerance, line, and load regulation.}
4 _{Maximum peak-to-peak noise expressed as a percentage of output voltage, 20 MHz bandwidth, and bypass capacitors of 10 μF and 0.1 μF.}
Ordering Information:
OPTIONS
RoHS lead solder exempt
RoHS compliant for all 6 substances
SUFFIXES TO ADD TO PART NUMBER
No RoHS character required.
Add “G” as the last character of the part number.
REV. MAR 31, 2006
Page 1 of 5
www.power-one.com