6383 Datasheet, PDF (2/2 Pages) Pomona Electronics – Banana Plug, User Installed

Pomona^®
Model 6383
Banana Plug, User Installed
(18-22 AWG)
FIGURE #1
A. Slide plastic housing over wire.
B. Place stripped wire (18, 20, or 22 AWG) end into terminal hole.
FIGURE #2
C. Crimp terminal using a bare-terminal style crimper. Retention force of joint should exceed 12 pounds to assure no
damage occurs to joint when housing is snapped into place.
FIGURE #3
D. Slide housing over plug and pull on wire until snap engages.
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm).
All specifications are to the latest revisions. Specifications are subject to change without notice.
Registered trademarks are the property of their respective companies. Made in USA
6/9/99
Sales: 800-490-2361 Fax: [phone]
SY/EH/LS
Technical Assistance: 800-241-2060
C:\Laura Goldberg\FlukeDataSheet\d6383_2_01.doc
PomonaACCESS 90835 [phone] or [phone]
More drawings available at www.pomonaelectronics.com
Last saved by PN
Page 2 of 2