4787 Datasheet, PDF (2/2 Pages) Pomona Electronics – Assembly Instructions

Model 4787 & Assembly Instructions
“N” Male Cable Plug
FIGURE #1
A. Slide clamp nut, flat washer and Vee gasket over cable.
B. Strip cable jacket to dimensions shown.
FIGURE #1A
C. Slide braid clamp over braid positioned with the inner shoulder against the cable jacket
D. Fold braid over braid clamp.
E. Strip Dielectric
FIGURE #2
F. Solder center contact to cable center conductor.
FIGURE #3
G. Slide clamp nut, flat washer and Vee gasket forward against braid clamp.
A. Place connector body over end of cable, thread clamp nut into body and tighten.
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm).
All specifications are to the latest revisions. Specifications are subject to change without notice.
Registered trademarks are the property of their respective companies. Made in USA
5/21/02 SY/EH/LS
Last saved by PN
Sales: 800-490-2361 Fax: [phone]
Technical Assistance: 800-241-2060
S:\Engineering\Release\DataSheets\FlukeDataSheet \d_AI_4787_2_02.doc
PomonaACCESS 90103 [phone] or [phone]
More drawings available at www.pomonaelectronics.com
Page 2 of 2