OXPCIE200 Datasheet, PDF (1/2 Pages) PLX Technology – PCI Express multi-port bridge

OXPCIe200, PCI Express multi-port bridge
Highlights
ƒ General Features
o Dual USB 2.0 host ports or USB 2.0 host port &
SPI/SRAM port, both with UART port configuration
o PCIe x1 end-point
- Integrated 2.5 GT/s SerDes
o 9 x 9mm², 156-pin TAPP package
o Typical Power: 300 mWatts
ƒ Key Features
o Standards Compliant
- PCI Express Base Specification, r1.1 (backwards
compatible with PCIe r1.0a)
- PCI Power Management Spec, r1.2
- ExpressCard, Mini Card & AIC compatible
- MSI/MSI-X compatible
- ASPM (L0S, L1) Link power management
o High Performance
- EHCI/OHCI compliant USB 2.0 ports
- Integrated USB2.0 full speed Phy
- Master or slave mode SPI or SRAM port
- Data rates of 60Mbps (SPI) & 25MB/s (SRAM)
- 8KB slave memory with direct access or 16 channel
FIFO modes
- PLX’s Oxford 950 UART
- DMA/bus mastering of both UARTs
- Asynchronous baud rates up to 15 Mbps
- 128-byte deep transmit/receive FIFO
- 9, 8, 7, 6 & 5-bit data framing
- Automated in & out-of-band flow control
- Advanced FIFO fill management
o Flexibility
- RS232, RS422, RS485 and IrDA operation
- Flexible clock pre-scaler from 1 to 31.875
- Programmable RS485 Turn-around delay
- 450 through 950 software compatibility
- 8 user-configurable GPIOs/PWMs
- Device parameters configurable via EEPROM
- 1.8V, 2.5V or 3.3V UART & GPIO I/O voltage
o Robust Operation
- Operation from a single 3.3 V supply
- Industrial temperature range -40°C to 85°C
o Broad Device Driver Support
- Windows 7/Vista/XP/2K
- WinCE 4.2/5.0/6.0
- Linux 2.4/2.6
Part of the Expresso family of high performance PCI
Express devices, the OXPCIe200 is a single chip
multi-port bridge with a rich set of connectivity ports
and advanced system management to maximize data
throughput while substantially reducing CPU and
system loading.
A fully integrated, single lane PCI Express endpoint
controller and SerDes enables host system access to
USB2.0 host, SPI and SRAM ports, a PLX
Technology’s ultra high performance Oxford 950
UART, plus user defined GPIOs/PWMs. The device
is configurable as dual USB host ports or one USB2.0
host port & one SPI or SRAM port providing a high
throughput communication path from a PCI Express
host system to a slave processor or peripherals.
Complete with the Oxide development tools and
certified device drivers, the OXPCIe200 is easy to
design-in and the ideal connectivity solution for a
diverse range of products including: inter-processor
communication, device control, I/O expansion and
multi-modem ExpressCard modules.
Accelerate your product development and time to
market with Oxide and PLX Technology’s easy to
design-in, high performance serial connectivity
solutions that just work.
© PLX Technology, www.plxtech.com
Page 1 of 2
7/10/2009, Version 1.1