PLL620-88 Datasheet, PDF (1/6 Pages) PhaseLink Corporation – Low Phase Noise XO (9.5-65MHz Output)

PLL620-88/-89
Low Phase Noise XO (9.5-65MHz Output)
FEATURES
• 19MHz to 65MHz crystal input.
• Output range: 9.5MHz – 65MHz
• Complementary outputs: PECL or LVDS output.
• Selectable OE Logic (enable high or enable low).
• Supports 2.5V or 3.3V Power Supply.
• Available in 16 pin TSSOP package.
DESCRIPTION
The PLL620-88 (PECL) and PLL620-89 (LVDS) are
XO ICs specifically designed to work with
fundamental or 3^rd OT crystals between 19MHz and
65MHz. The selectable divide by two feature extends
the operation range from 9.5MHz to 65MHz. They
require very low current into the crystal resulting in
better overall stability. The OE logic feature allows
selection of enable high or enable low.
BLOCK DIAGRAM
Oscillator
X+ ^Amplifier
X-
O
E
Q
Q
S2
PLL620-8X Block Diagram
PIN CONFIGURATION
VDD 1
XIN 2
XOUT 3
DNC 4
S2 5
OE 6
N/C 7
GND 8
16 DNC
15 DNC
14 GNDBUF
13 QBAR
12 VDDBUF
11 Q
10 GNDBUF
9 GND
OUTPUT SELECTION AND ENABLE
OE_SELECT OE_CTRL
State
0
0
Tri-state
1 (Default) Output enabled
1 (Default)
0 (Default) Output enabled
1
Tri-state
Input selection: Bond to GND to set to “0”, bond to VDD to set to “1”
No connection results to “default” setting through
internal pull-up/-down.
OE_CTRL:
Logical states defined by PECL levels if
OE_SELECT is “1”
Logical states defined by CMOS levels if
OE_SELECT is “0”
OUTPUT FREQUENCY DIVIDE BY
TWO SELECTOR
S2
Output
0
Intput/2
1
Input
47745 Fremont Blvd., Fremont, California 94538 Tel [phone] Fax [phone] www.phaselink.com Rev 12/08/04 Page 1