PAS202BCA Datasheet, PDF (8/15 Pages) Pixart Imaging Inc. – PAS202BCA SINGLE-CHIP CMOS VGA COLOR DIGITAL IMAGE SENSOR PAS202BBA SINGLE-CHIP CMOS VGA B&W DIGITAL IMAGE SENSOR

PixArt Imaging Inc.
PAS202BCA/PAS202BBA
CMOS Image Sensor IC
SDA
SCL
DATA
STABLE
DATA
CHANGE
ALLOWED
Fig 4.2 Valid Data
4.2 Data Transfer Format
4.2.1 Master transmits data to slave (write cycle)
§ S : Start
§ A : Acknowledge by slave
§ P : Stop
§ RW : The LSB of 1^ST byte to decide whether current cycle is read or write cycle.
RW=1 read cycle, RW=0 write cycle.
§ SUBADDRESS : The address values of PAS202BCA/PAS202BBA internal control registers
(Please refer to PAS202BCA/PAS202BBA register description)
1ST BYTE
S
SLAVE ID (7 BIT)
RW A
2ND BYTE
SUBADDRESS (8 BIT)
n BYTEs + A
A DATA A DATA
A
P
MSB
LSB=0
During write cycle, the master generates start condition and then places the 1^st byte data that are combined
slave address (7 bits) with a read/write control bit to SDA line. After slave(PAS202BCA/PAS202BBA) issues
acknowledgment, the master places 2^nd byte (sub-address) data on SDA line. Again follow the
PAS202BCA/PAS202BBA acknowledgment, the master places the 8 bits data on SDA line and transmit to
PAS202BCA/PAS202BBA control register (address was assigned by 2^nd byte). After
PAS202BCA/PAS202BBA issue acknowledgment, the master can generate a stop condition to end of this
write cycle. In the condition of multi-byte write, the PAS202BCA/PAS202BBA sub-address is automatically
increment after each DATA byte transferred. The data and A cycles is repeat until last byte write. Every control
All rights strictly reserved any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.
8
PixArt Imaging Inc.
E-mail: [e-mail]
V1.2, May. 2002