PAS6167 Datasheet, PDF (19/19 Pages) Pixart Imaging Inc. – CMOS QCIF+ DIGITAL IMAGE SENSOR

PixArt Imaging Inc.
PAS6167
CMOS Image Sensor IC
Recommended Condition For Infrared Reflow
Carefully observe the mounting conditions, recommended temperature profile when
Mounting infrared reflows is show in the figure below.
After mounting on the mother board, it must be dispense epoxy in side of the CSP package.
ô Reflow Profile
3FDPNNFOE
3FGMPX
1SPGJMF
Melting area



Pre-heat



           
5JNF ^{( Sec )}
Recommend Pb-free solder paste vender & type :
Programming
rate
1.5~2.5 ^oC/sec
Pre-heat
170~200^oC
90 +/- 30 sec
1. Almit LFM-48W TM-HP
2. Senju M705-GRN360-K
Melting area
>220^oC 30~50sec
with peak temperature 230~245^oC
ô Dispense Epoxy
Epoxy
All rights strictly reserved any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.
PixArt Imaging Inc.
E-mail: [e-mail]
V1.0,
19
2009/08/12