PAW3504 Datasheet, PDF (10/13 Pages) Pixart Imaging Inc. – PURE USB OPTICAL MOUSE SINGLE CHIP

PixArt Imaging Inc.
PAW3504
Pure USB Optical Mouse Sensor Single Chip
6. Referencing Application Circuit
Y1 24Mhz
U1
VDD_5V
R1 D1
VDD_5V
R6
*R3 OPEN
1 _OSCIN
OSCOUT ¹⁴
BL _{2 BL}
Z1 ¹³
LED
*R2 OPEN
C4 1uF
VDD_5V_10R
10 ohm
3 _LED
4 _VDDQ
5 _VSS
6 _VDD5V
7 _VDDA
Z2 ¹²
BM ^{11 BM}
BR ^{10 BR}
D- ⁹
D+ ⁸
C1
C3
C6
+
PAW3504
0.1uF 1uF
27pF
VDD_5V_10R
ENSW1
Z1
Z2 ^COM
C5
0.1uF
R4
R5
C7
33 ohm
33 ohm
27pF
VDD_5V
C2
+
10uF
JP1
VBUS
GND
Shield
D-
D+
USB CABLE
Note:
1. *R2 is left for PAN3401 with PS/2 interface
2. *R3 is left for PAN3502 RC Oscillator
3. R4,R5,C6,C7 are for EMCimmunity
4. USB cable connector JP1 is suggested to has the pin sequence like this:
VBUS, GND, Shield, D-, D+
Figure 7. Application Circuit for PAW3504
6.2 PCB Layout Guideline
The following guidelines apply to component placement and routing on the PCB. That will get an optimum
EMC solution and tracking performance.
6.2.1 Key Components Placement Rules
1. Place resonator (Y1) near SENSOR pin1 and pin 14.
2. Place bulk capacitor (C2) and bypass (C5) near the USB CABLE.
3. Place C1 and C3 near SENSOR pin 6 and pin 7.
4. The C6/C7 and R4/R5 should be placed as close to the USB CABLE.
6.2.2 Routing Rules
1. Caps for pins 4, 6, 7 trace length must be less than 5 mm.
2. The trace length of OSCOUT, OSCIN must be less than 10 mm.
3. Other general rules refer file”PAW3504DLY PCB Layout Guide”
All rights strictly reserved any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.
PixArt Imaging Inc.
E-mail: [e-mail]
10
V1.0 June. 2008