|
74HC4053_90 Datasheet, PDF (12/17 Pages) NXP Semiconductors – Triple 2-channel analog multiplexer/demultiplexer | |||
|
◁ |
Philips Semiconductors
Triple 2-channel analog
multiplexer/demultiplexer
Product speciï¬cation
74HC/HCT4053
ADDITIONAL AC CHARACTERISTICS FOR 74HC/HCT
Recommended conditions and typical values
GND = 0 V; Tamb = 25 °C
SYMBOL
PARAMETER
typ.
UNIT
VCC
(V)
VEE
(V)
Vis(p-p)
(V)
CONDITIONS
V(pâp)
fmax
CS
sine-wave distortion
f = 1 kHz
sine-wave distortion
f = 10 kHz
switch âOFFâ signal
feed-through
crosstalk between
any two switches/
multiplexers
crosstalk voltage between
control and any switch
(peak-to-peak value)
minimum frequency response
(â3dB)
maximum switch capacitance
independent (Y)
common (Z)
0.04 %
0.02 %
0.12 %
0.06 %
â50 dB
â50 dB
â60 dB
â60 dB
2.25
4.5
2.25
4.5
2.25
4.5
2.25
4.5
â2.25
â4.5
â2.25
â4.5
â2.25
â4.5
â2.25
â4.5
4.0
8.0
4.0
8.0
note 1
note 1
RL = 10 kâ¦; CL = 50 pF
(see Fig.14)
RL = 10 kâ¦; CL = 50 pF
(see Fig.14)
RL = 600 â¦; CL = 50 pF
f = 1 MHz see (Fig.12 and 15)
RL = 600 â¦; CL = 50 pF;
f = 1 MHz (see Fig.16)
110 mV 4.5 0
220 mV 4.5 â4.5
RL = 600 kâ¦; CL = 50 pF;
f = 1 MHz (E or Sn,
square-wave between VCC
and GND, tr = tf = 6 ns
(see Fig.17)
160 MHz 2.25 â2.25 note 2 RL = 50 ⦠; CL = 10 pF
170 MHz 4.5 â4.5
(see Fig.13 and 14)
5
pF
8
pF
Notes to the AC characteristics
1. Adjust input voltage Vis to 0 dBm level (0 dBm = 1 mW into 600 â¦).
2. Adjust input voltage Vis to 0 dBm level at VOS for 1 MHz (0 dBm = 1 mW into 50 â¦).
General note
Vis is the input voltage at an nYn or nZ terminal, whichever is assigned as an input.
Vos is the output voltage at an nYn or nZ terminal, whichever is assigned as an output
December 1990
12
|
▷ |