PCKEP14 Datasheet, PDF (1/15 Pages) NXP Semiconductors – 2.5 V/3.3 V 1:5 differential ECL/PECL/HSTL clock driver

PCKEP14
2.5 V/3.3 V 1:5 differential ECL/PECL/HSTL clock driver
Rev. 01 — 30 October 2002
Product data
1. Description
The PCKEP14 is a low skew 1-to-5 differential driver, designed with clock distribution
in mind, accepting two clock sources into an input multiplexer. The ECL/PECL input
signals can be either differential or single-ended (if the V_BB output is used). HSTL
inputs can be used when the PCKEP14 is operating under PECL conditions.
The PCKEP14 specifically guarantees low output-to-output skew. Optimal design,
layout, and processing minimize skew within a device, and from device to device.
To ensure that the tight skew specification is realized, both sides of any differential
output need to be terminated identically into 50 Ω resistors, even if only one output is
being used. If an output pair is unused, both outputs may be left open (unterminated)
without affecting skew.
The common enable (EN) is synchronous, outputs are enabled/disabled in the LOW
state. This avoids a runt clock pulse when the device is enabled/disabled, as can
happen with an asynchronous control. The internal flip-flop is clocked on the falling
edge of the input clock, therefore, all associated specification limits are referenced to
the negative edge of the clock input.
The PCKEP14, as with most other ECL devices, can be operated from a positive V_CC
supply in PECL mode. This allows the PCKEP14 to be used for high performance
clock distribution in +3.3 V or +2.5 V systems.
2. Features
s 100 ps device-to-device skew
s 25 ps within device skew
s 400 ps typical propagation delay
s Maximum frequency > 2 GHz (typical)
s Contains temperature compensation
s PECL and HSTL mode: V_CC = 2.375 V to 3.8 V with V_EE = 0 V
s NECL mode: V_CC = 0 V with V_EE = −2.375 V to −3.8 V
s LVDS input compatible
s Open input default state.