ISP1103 Datasheet, PDF (1/17 Pages) NXP Semiconductors – Universal Serial Bus transceiver

ISP1103
Universal Serial Bus transceiver
Rev. 01 — 4 October 1999
Preliminary specification
1. General description
The ISP1103 is a single-chip generic Universal Serial Bus (USB) transceiver that is
fully compliant with the Universal Serial Bus Specification Rev. 1.1. It allows 3.3 V
USB Application Specific ICs (ASICs) and Programmable Logic Devices (PLDs) to
interface with the physical layer of the Universal Serial Bus. It supports transmitting
and receiving serial data at both full-speed (12 Mbit/s) and low-speed (1.5 Mbit/s)
data rates. It also supports the low-power single-ended input receiver interface in
‘suspend’ mode operation. The ISP1103 operates on a 3.3 V supply voltage.
The pin configuration conforms to the ‘Serial Interface Engine’ from the Universal
Serial Bus Implementers Forum (USB-IF). The ISP1103 allows for both the ‘USB-IF
Standard Data Interface’ and the ‘Philips Encoded Data Interface’. The ISP1103 is
fully pin compatible with the industry-standard Philips Semiconductors USB
transceiver PDIUSBP11A.
2. Features
s Complies with Universal Serial Bus Specification Rev. 1.1
s Supports full-speed (12 Mbit/s) and low-speed (1.5 Mbit/s) serial data rates
c
c
s Slew-rate controlled differential data driver
s Differential input receiver with wide common-mode range and very high data input
sensitivity
s Stable RCV output during SE0 condition
s Two single-ended receivers with hysteresis
s Supports ‘Philips Encoded Data Interface’ and ‘USB-IF Standard Data Interface’
s Low-power operation in ‘suspend’ mode
s Operates on a 3.3 V supply voltage
s Fully backward compatible with PDIUSBP11A
s Compatible with VHDL ‘Serial Interface Engine’ from USB Implementers Forum
s Higher than 8 kV ESD protection
s Full industrial operating temperature range −40 to +85 °C
s Available in SO14, SSOP14 and TSSOP14 packages.