74LVC373A_15 Datasheet, PDF (1/19 Pages) NXP Semiconductors – Octal D-type transparent latch with 5 V tolerant inputs/outputs; 3-state

74LVC373A
Octal D-type transparent latch with 5 V tolerant
inputs/outputs; 3-state
Rev. 3 — 22 November 2012
Product data sheet
1. General description
The 74LVC373A consists of eight D-type transparent latches, featuring separate D-type
inputs for each latch and 3-state true outputs for bus-oriented applications. A latch enable
input (pin LE) and an output enable input (pin OE) are common to all internal latches.
When pin LE is HIGH, data at the D-inputs (pins D0 to D7) enters the latches. In this
condition, the latches are transparent, that is, a latch output will change each time its
corresponding D-input changes. When pin LE is LOW, the latches store the information
that was present at the D-inputs one set-up time preceding the HIGH-to-LOW transition of
pin LE.
When pin OE is LOW, the contents of the eight latches are available at the Q-outputs (pins
Q0 to Q7). When pin OE is HIGH, the outputs go to the high-impedance OFF-state.
Operation of input pin OE does not affect the state of the latches.
Inputs can be driven from either 3.3 V or 5 V devices. When disabled, up to 5.5 V can be
applied to the outputs. These features allow the use of these devices as translators in
mixed 3.3 V and 5 V applications.
The 74LVC373A is functionally identical to the 74LVC573A, but has a different pin
arrangement.
2. Features and benefits
 5 V tolerant inputs/outputs for interfacing with 5 V logic
 Wide supply voltage range from 1.2 V to 3.6 V
 CMOS low power consumption
 Direct interface with TTL levels
 High-impedance outputs when V_CC = 0 V
 Complies with JEDEC standard:
 JESD8-7A (1.65 V to 1.95 V)
 JESD8-5A (2.3 V to 2.7 V)
 JESD8-C/JESD36 (2.7 V to 3.6 V)
 ESD protection:
 HBM JESD22-A114F exceeds 2000 V
 MM JESD22-A115-B exceeds 200 V
 CDM JESD22-C101E exceeds 1000 V
 Specified from 40 C to +85 C and 40 C to +125 C