74ALVC162334A_15 Datasheet, PDF(1/19 Page) NXP Semiconductors – 16-bit registered driver with inverted register enable and 30 W termination resistors (3-state)

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

74ALVC162334A_15 Datasheet, PDF (1/19 Pages) NXP Semiconductors – 16-bit registered driver with inverted register enable and 30 W termination resistors (3-state)

74ALVC162334A

16-bit registered driver with inverted register enable and 30 â¦

termination resistors (3-state)

Rev. 03 â 13 December 2006

Product data sheet

1. General description

The 74ALVC162334A is a 16-bit universal bus driver. Data ï¬ow is controlled by

active LOW output enable (OE), active LOW latch enable (LE), and clock input (CP).

When LE is LOW, the A to Y data ï¬ow is transparent. When LE is HIGH and CP is held at

LOW or HIGH, the data is latched; on the LOW to HIGH transient of CP, the A data is

stored in the latch/ï¬ip-ï¬op.

The 74ALVC162334A is designed with 30 â¦ series resistors in both HIGH or LOW output

stages.

When OE is LOW, the outputs are active. When OE is HIGH, the outputs go to the

high-impedance OFF-state. Operation of the OE input does not affect the state of the

latch/ï¬ip-ï¬op.

To ensure the high-impedance state during power-up or power-down, OE should be tied to

VCC through a pull-up resistor; the minimum value of the resistor is determined by the

current-sinking capability of the driver.

2. Features

I Wide supply voltage range of 1.2 V to 3.6 V

I Complies with JEDEC standard 8-1A

I CMOS low power consumption

I Direct interface with TTL levels

I Current drive: Â±24 mA at 3.0 V

I MULTIBYTE ï¬ow-through standard pinout architecture

I Low inductance multiple VCC and GND pins for minimum noise and ground bounce

I Output drive capability 50 â¦ transmission lines at 85 Â°C

I Integrated 30 â¦ termination resistors

I Input diodes to accommodate strong drivers

▷