English
Language : 

PDA100W-1A0GB Datasheet, PDF (2/4 Pages) Phihong USA Inc. – 100W Constant Current LED Driver PDA100W LED Power Supply with 0-10V Dimming
PDA100W Characteristics
Input:
AC Input Voltage Range
108VAC to 304VAC
Nominal AC Input Voltage
120 to 277VAC
AC Input Frequency
47~63Hz
Maximum Input Current
≤ 1.26A
Leakage Current
0.75mA maximum at 120VAC Input
Inrush Current
< 80A
OUTPUT:
Power Factor
≥ 0.9
Output Current Ripple
<105mA (p-p)
Efficiency
Model
PDA100W-700GB
PDA100W-1A0GB
PDA100W-1A4GB
PDA100W-1A8GB
PDA100W-2A1GB
Typical Efficiency
91%
91%
89%
89%
89%
Turn-on Delay Time
<0.5s maximum at nominal AC Power ON
Environmental:
Temperature
Operation Tc
Non-operation
Operating Humidity
-40 to 83°C
-40 to +90°C
5 to 98%
Dimming Grounding
Dim(-) and Vout(-) must never be connected
together to ensure proper operation and isolation
requirements
WWW.PHIHONG.COM
EMC
FCC Part 15 Class A
Immunity
IEC61000-4-2
IEC61000-4-5
IEC61000-4-11
IEC61000-3-2 Class C
Input Over Current Protection
The input power line will be fused with a 3.15A fuse
Short-Circuit Protection
The Driver will withstand a short circuit across the outputs
without damage.
Over Temperature Protection
The load will drop by 50% automatically if the case
temperature exceeds the recommended limit.
Over Voltage Protection
During no load condition, the over voltage protection
trigger level should be less than 195Vrms.
Dielectric Withstand (Hi-pot) Test
Primary to secondary: 4242VDC for 1 minute, 5.5mA
Insulation Resistance
Primary to secondary: >5M Ohm 500VDC, 1 Minute
Wire Connections
Position
Terminal
Color
Line
Black
Neutral
White
Ground Green/Yellow
Vout+
Red
Vout-
Blue
20V
Yellow
Dim+
Violet
Dim-
Grey
Specification
AWG18 Solid Wire
AWG18 Solid Wire
AWG18 Solid Wire
AWG18 Solid Wire
AWG18 Solid Wire
AWG22 Solid Wire
AWG22 Solid Wire
AWG22 Solid Wire
Length
390mm
390mm
390mm
390mm
390mm
390mm
390mm
390mm
Warranty
5 Years