DLPO-2_15 Datasheet, PDF (1/13 Pages) PETERMANN-TECHNIK – Differential Oscillator for Low Cost

PETERMANN-TECHNIK GmbH
Lechwiesenstr. 13 ∙ D-86899 ∙ Landsberg am Lech
Tel: [phone] ∙ Fax: [phone]
[e-mail] ∙ www.petermann-technik.com
HIGH PERFORMANCE DIFFERENTIAL OSCILLATOR
SERIES „DLPO-2“
220.0—800.0 MHz
FEATURES
+ 100% pin-to-pin drop-in replacement to quartz and MEMS based XO
+ Differential Oscillator for Low Cost
+ LVCMOS, LVPECL, LVDS and CML output signal possible
+ Low Power Consumption
+ Excellent low RMS phase jitter
+ Excellent long time reliability
+ Very tight frequency stability as low as ±10 ppm
+ Outstanding long term aging
+ Standard housings: 5.0x3.2; 7.0x5.0 mm
+ Pb-free, RoHS and REACH compliant / MSL1@260°C
APPLICATIONS
+ Server, Router, RAID controller
+ Gigabit Ethernet, 10 Gigabit Ethernet, Fiber Channel
+ SATA / SAS,PCI-Express, Fully Buffered DIMM
+ System clock, Networking and computing,
+ etc.
PIN DESCRIPTION
PIN
SYMBOL
1
OE/ST
2
NC
3
GND
4
OUT+
5
OUT-
6
VDD
Input
NA
Power
Output
Output
Power
FUNCTIONALITY
Standby or Output Enable pin for OUT+ and OUT-.
OE:
When High or Open : OUT+ and OUT- = active
When Low : OUT+ and OUT- = High Impedance state
ST:
When High or Open : OUT+ and OUT- = active
When Low : OUT+ and OUT- = High Impedance State
Do not connect pin, leave it floating.
VDD Power Supply Ground. Connect to Ground
220 to 800 MHz programmable clock output.
Power Supply Voltage
TOP VIEW
OE/ST ₁
NC 2
GND 3
6 ^VDD
5 OUT-
4 OUT+
CRYSTALS ∙ OSCILLATORS ∙ CERAMIC RESONATORS ∙ CERAMIC FILTERS ∙ SAW COMPONENTS
PAGE 1 OF 13 I SPEC 01 I REV.00 I NOVEMBER 2014