PI3VDP612 Datasheet, PDF (5/15 Pages) Pericom Semiconductor Corporation – High Bandwidth 6-differential Channel, 1:2 Demux for DisplayPortTM rev 1.1a Signal Switching

PI3VDP612
High Bandwidth 6-differential channel, 1:2 Demux
for DisplayPortTM rev 1.1a Signal Switching
Maximum Ratings
(Above which useful life may be impaired. For user guidelines, not tested.)
Storage Temperature .....................................................–65°C to +150°C
Supply Voltage to Ground Potential ................................–0.5V to +3.6V
DC Input Voltage ............................................................... –0.7V to 3.6V
DC Output Current ....................................................................... 120mA
Power Dissipation ............................................................................ 0.5W
Note: Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the device. This
is a stress rating only and functional operation of the device
at these or any other conditions above those indicated in the
operational sections of this specification is not implied. Expo-
sure to absolute maximum rating conditions for extended
periods may affect reliability.
DC Electrical Characteristics for Switching over Operating Range (T_A = –40°C to +85°C, V_DD =
3.3V +/-10%)
Paramenter Description
Test Conditions⁽¹⁾
Min Typ⁽²⁾ Max Units
VIH
Input HIGH Voltage
Guaranteed HIGH level
VIL
Input LOW Voltage
Guaranteed LOW level
VIK
Clamp Diode Voltage
V_DD = Max., I_IN = –18mA
IIH
Input HIGH Current
V_DD = Max., V_IN = V_DD
IIL
Input LOW Current
V_DD = Max., V_IN = GND
1.6
0.75 V
–0.7 –1.2
±5
µA
±5
R_ON
On resistance between input ^VDD ^{= 3.0V, -0.6V<V}INPUT^<0.6V
to output
V_DD = 3.0V, 1.0V<V_INPUT<1.5V
7
Ohm
10
Ohm
Power Supply Characteristics
Parameters Description
I_CC
Quiescent Power Supply Current
Test Conditions⁽¹⁾
Min.
V_DD = Max., V_IN = GND or V_DD
Typ.⁽²⁾ Max.
40
100
Units
µA
Dynamic Electrical Characteristics Over the Operating Range (TA= -40º to +85ºC, V_DD = 3.3V
+/-10%, GND=0V)
Parameter
Description
Test Conditions
Typ.⁽²⁾ Units
X_TALK
Crosstalk on High Speed Channels
See Fig. 1 for Measurement
Setup
f= 1.35 GHz
f = 100 MHz
-33dB
-48dB
O_IRR
f= 1.35 GHz -33dB _dB
OFF Isolation on High Speed Channels
See Fig. 2 for Measurement
Setup,
f = 100 MHz
-56dB
I_LOSS
Differential Insertion Loss on High
Speed Channels
@2.7Gbps (see figure 3)
-1.5
BW_Dx±
Bandwidth -3dB for Main high speed
path (Dx±)
See figure 3
3.25
BW_AUX/HPD -3dB BW for AUX and HPD signals See figure 3
1.5
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V_DD = 3.3V, T_a = 25°C ambient and maximum loading.
dB
GHz
GHz
11-0002
5
PS8928D
11/03/10