PI3A125 Datasheet, PDF (5/8 Pages) Pericom Semiconductor Corporation – SOTINY Low Voltage SPST Analog Switch/Bus Switch

PI3A125
SOTINY Low Voltage SPST
Analog Switch/Bus Switch _{1122334455667788990011223344556677889900112233445566778899001122112233445566778899001122334455667788990011223344556677889900112211223344556677889900112233445566778899001122334455667788990011221122334455667788990011223344556677889900112233445566778899001122112233445566778899001122}
Test Circuits and Timing Diagrams (continued)
V_CC = 3.3V ±0.3V
From Output
Under Test
500Ω
2 x VCC
S1
Open
GND
C_L = 50pF
(See Note 1)
500Ω
Test
t_pd
t_PLZ/t_PZL
t_PHZ/t_PZH
S1
Open
2 x V_CC
GND
Load Circuit
Input
VCC/2
tPLH
VCC/2
tPHL
VCC
0V
Output
VCC/2
VOH
VCC/2
VOL
Voltage Waveforms
Propagation Delay Times
Output
Control
Output
Waveform 1
S1 at 2 x VCC
(see Note 2)
Output
Waveform 2
S1 at GND
(see Note 2)
VCC/2
tPZL
VCC/2
tPLZ
VCC
0V
VCC/2
tPZH
VCC/2
VCC
VOL+0.3V
tPHZ
VOH –0.3V
VOL
VOH
0V
Voltage Waveforms
Propagation Delay Times
Figure 2. Test Circuit and Voltage Waveforms for V_CC = 3.3V
Notes:
1. C_L includes probe and jig capacitance.
2. Waveform 1 is for an output with internal conditions such that the output is LOW except when disabled by the output control.
Waveform 2 is for an output with internal conditions such that the output is HIGH except when disabled by the output control.
3. All input pulses are supplied by generators having the following characteristics: PRR <10 MHz, Z_O = 50Ω, t_r ≤ 2ns, t_f ≤ 2ns.
4. The outputs are measured one at a time with one transition per measurement.
5. t_PLZ and t_PHZ are the same as t_dis.
6. t_PZL and t_PZH are the same as t_en.
7. t_PLH and t_PHL are the same as t_pd.
PS8575A
06/27/04
5