PI74FCT16244T_07 Datasheet, PDF (3/9 Pages) Pericom Semiconductor Corporation – Fast CMOS 16-Bit Buffer/Line Drivers

PI74FCT16244T/162244T
16-Bit Buffer/Line Drivers
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ........................................................ –65°C to +150°C
Ambient Temperature with Power Applied ......................... –40°C to +85°C
Supply Voltage to Ground Potential (Inputs & Vcc Only) ... –0.5V to +7.0V
Supply Voltage to Ground Potential (Outputs & D/O Only) –0.5V to +7.0V
DC Input Voltage ................................................................ –0.5V to +7.0V
DC Output Current .......................................................................... 120mA
Power Dissipation ............................................................................... 1.0W
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the
device. This is a stress rating only and functional
operation of the device at these or any other conditions
above those indicated in the operational sections of this
specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may
affect reliability.
DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5.0V ±10%)
Parameters Description
Test Conditions⁽¹⁾
Min.
VIH
Input HIGH Voltage
VIL
Input LOW Voltage
IIH
Input HIGH Current
IIH
Input HIGH Current
IIL
Input LOW Current
IIL
Input LOW Current
IOZH
High Impedance
IOZL
Output Current
VIK
Clamp Diode Voltage
IOS
Short Circuit Current
IO
Output Drive Current
VH
Input Hysteresis
Guaranteed Logic HIGH Level
Guaranteed Logic LOW Level
Standard Input, VCC = Max.
Standard I/O, VCC = Max.
Standard Input , VCC = Min.
Standard I/O, VCC = Min.
VCC = Max.
VCC = Max.
VCC = Min., IIN = –18mA
VCC = Max.⁽³⁾, VOUT = GND
VCC = Max.⁽³⁾, VOUT = 2.5V
2.0
VIN = VCC
VIN = VCC
VIN = GND
VIN = GND
VOUT = 2.7V
VOUT = 0.5V
–80
–50
Typ.⁽²⁾
–0.7
–140
100
Max.
0.8
1
1
–1
–1
1
–1
–1.2
–320
–180
Units
V
V
μA
μA
μA
μA
μA
μA
V
mA
mA
mV
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at Vcc = 5.0V, +25°C ambient and maximum loading.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
07-0059
3
PS2031L
02/26/07