PI3VEDP212 Datasheet, PDF (3/8 Pages) Pericom Semiconductor Corporation – 2-lane DisplayPort Switch/Mux for DP Driven Panels with Triple Control Pins

PI3VeDP212
2-lane DisplayPort™ Switch/Mux for
DP Driven Panels with Triple Control Pins
Maximum Ratings
(Above which useful life may be impaired.For user guidelines, not tested.)
Storage Temperature .....................................................–65°C to +150°C
Supply Voltage to Ground Potential ................................–0.5V to +3.6V
DC Input Voltage ............................................................... –0.5V to 3.6V
DC Output Current ....................................................................... 120mA
Power Dissipation ............................................................................ 0.5W
Note: Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the device. This
is a stress rating only and functional operation of the device
at these or any other conditions above those indicated in the
operational sections of this specification is not implied. Expo-
sure to absolute maximum rating conditions for extended
periods may affect reliability.
DC Electrical Characteristics for Switching over Operating Range(T_A = –40°C to +85°C, V_DD = 3.3V +/-10%)
Parameter
Description
Test Conditions⁽¹⁾
Min Typ⁽²⁾ Max Units
VIH
Input HIGH Voltage
Guaranteed HIGH level
1.5
V_IL
Input LOW Voltage
Guaranteed LOW level
–0.5
0.65
V
V_IK
Clamp Diode Voltage
V_DD = Max., I_IN = –18mA
–0.7 –1.2
IIH
Input HIGH Current
V_DD = Max., V_IN = V_DD
±5
I_IL
Input LOW Current
V_DD = Max., V_IN = GND
±5
µA
I_OFF
I/O leakage when part is off
V_DD = 0V, Vinput = 0V to 3.6V
50
Power Supply Characteristics (T_A = 0°C to +70°C)
Parameters
Description
Test Conditions⁽¹⁾
I_CC
Quiescent PowerSupply Current
V_DD = Max., V_IN = GND or V_DD
Min.
Typ.⁽²⁾
Max.
70
Units
µA
Dynamic Electrical Characteristics Over the Operating Range (TA= -40º to +85ºC, VDD = 3.3V +/-10%,
GND=0V)
Parameter
Description
Test Conditions
Typ.⁽²⁾
Units
X_TALK
Crosstalk on High
Speed Channels
See Fig. 1 for Measurement Setup
f= 1.35 GHz
f = 100 MHz
-33dB
-48dB
O_IRR
OFF Isolation on
High Speed Chan- See Fig. 2 for Measurement Setup,
nels
f= 1.35 GHz
-33dB
dB
f = 100 MHz
-56dB
Differential
I_LOSS
Insertion Loss on
High Speed Chan-
@2.7Gbps
-1.5
nels
BW
Bandwidth -3dB See Fig. 3 for Differential Insertion Loss
3.25
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V_DD = 3.3V, T_a = 25°C ambient and maximum loading.
dB
GHz
11-0082
3
PS9057A
08/23/11