PI3B3125 Datasheet, PDF (3/6 Pages) Pericom Semiconductor Corporation – 3.3V, 4-Bit, 2-Port Nanoswitch w/Individual Enables

PI3B3125/PI3B3126
3.3V, 4-Bit, 2-Port NanoSwitch^™
w/Individual Enables
DC Electrical Characteristics (Over the Operating Range, T_A = –40°C to +85°C, V_CC = 3.3V ±10%)
Parameters
Description
Test Conditions⁽¹⁾
Min. Typ.⁽²⁾
V_IH
Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0
V_IL
Input LOW Voltage
Guaranteed Logic LOW Level
–0.5
I_IH
Input HIGH Current
V_CC = Max., V_IN = V_CC
I_IL
Input LOW Current
V_CC = Max., V_IN = GND
I_OFF
Off Current
V_CC = 0, V_OUT = 3 to 3.6V
V_IK
Clamp Diode Voltage
V_CC = Min., I_IN = –18mA
R_ON
Switch On-Resistance⁽³⁾
V_CC = Min., V_IN = 0.0V, I_ON = 48mA or 60mA
V_CC = Min., V_IN = 2.4V, I_ON = 15mA
5
10
Max.
0.8
±1
±1
10
–1.2
8
17
Units
V
µA
V
Ω
Capacitance (T_A = 25°C, f = 1 MHz)
Parameters⁽⁴⁾
Description
Test Conditions
Typ.
Units
C_IN
C_OFF
Input Capacitance
A/B Capacitance, Switch Off
V_IN = 0V
3.5
pF
8
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V_CC = 3.3V, T_A = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined by the lower of the
voltages on the two (A, B) pins.
4. This parameter is determined by device characterization but is not production tested.
Power Supply Characteristics
Parameters
Description
I_CC
Quiescent Power Supply Current
ΔI_CC
Supply Current per Input HIGH
Test Conditions⁽¹⁾
V_CC = Max. V_IN = GND or V_CC
V_CC = Max. V_IN = 3.0V⁽³⁾
Min.
Typ.⁽²⁾
0.1
Max.
3
750
Units
µA
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device.
2. Typical values are at V_CC = 3.3V, +25°C ambient.
3. Per driven input (control inputs only); A and B pins do not contribute to I_CC.
3
PS8153F
09/09/04