 English |
|
|
|
|
|
|
|
| PI3USB102 Datasheet, PDF (2/7 Pages) Pericom Semiconductor Corporation – USB 2.0 High-Speed (480 Mbps) Signal Switch Targeted for Battery Powered Applications | |||
| |||
| ◁ |
PI3USB102
USB 2.0 High-Speed (480 Mbps) Signal Switch
Targeted for Battery Powered Applications
Maximum Ratings
(Above which useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ......................................................â65°C to +150°C
Supply Voltage to Ground Potential .................................â0.5V to +4.6V
DC Input Voltage ..................................................... â0.5V to VCC +0.5V
DC Output Current ........................................................................120mA
Power Dissipation .............................................................................0.5W
Note: Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the device. This
is a stress rating only and functional operation of the device
at these or any other conditions above those indicated in the
operational sections of this speciï¬cation is not implied. Ex-
posure to absolute maximum rating conditions for extended
periods may affect reliability.
DC Electrical Characteristics for USB 2.0 Switching over Operating Range
(TA = â40°C to +85°C, VCC = 3.0 - 4.4V)
Paramenter
Description
Test Conditions(1)
Min.
Typ.(2) Max. Units
VIH
Input HIGH Voltage
VIL
Input LOW Voltage
Guaranteed
VCC = 4.2V
1.8
HIGH level
VCC = 3.3V
1.6
Guaranteed HIGH level
V
0.8
VIK
Clamp Diode Voltage
VCC = Max., IIK = â18mA
-1.2
IIH
Input HIGH Current
IIL
Input LOW Current
VCC = Max., VIH = VCC
VCC = Max., VIL = GND
±5
uA
±5
RON
Switch On-Resistance(3)
VCC = Min., -0.4V ⤠Vinput ⤠1.0V,
ION = â40mA
5.5 6.0
RFLAT(ON) On-Resistance Flatness(3)
VCC = Min., -0.4V ⤠Vinput ⤠1.0V,
ION = -40mA
1.5
Ω
RON
On-Resistance match from cen- VCC = Min., -0.4V ⤠Vinput ⤠1.0V,
ter ports to any other port(3)
ION = -40mA
0.9 2.0
Notes:
1. For max. or min. conditions, use appropriate value speciï¬ed under Electrical Characteristics for the applicable device type.
2. VCC = 3.0 - 4.4V, TA = 25°C ambient and maximum loading.
3. Measured by the voltage drop between D and Dn pin at indicated current through the Switch On-Resistance is determined by the lower of the
voltages on the two (D, Dn) pins.
Power Supply Characteristics (VCC = 3.0 - 4.4V)
Parameters
Description
Test Conditions(1)
Min. Typ. Max.
ICC
Quiescent Power Supply Current VCC = Max., VSEL = GND or VCC
50
Notes:
1. For max. or min. conditions, use appropriate value speciï¬ed under Electrical Characteristics for the applicable device type.
Units
nA
07-0095
2
P-0.6
03/27/07
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese