PI3USB10 Datasheet, PDF (2/6 Pages) Pericom Semiconductor Corporation – 3.3V, Wide Bandwidth, 2-Channel, 2:1 Mux/DeMux USB 2.0 Switch w/ Single Enable

PI3USB10
3.3V, Wide Bandwidth, 2-Channel,
2:1 Mux/DeMux USB 2.0 Switch
Maximum Ratings
(Above which useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ......................................... –65°C to +150°C
Supply Voltage to Ground Potential .................... –0.5V to +4.0V
DC Input Voltage ................................................. –0.5V to +5.5V
DC Output Current ........................................................... 120mA
Power Dissipation ................................................................ 0.5W
Note: Stresses greater than those listed under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is a stress
rating only and functional operation of the device at these or any other
conditions above those indicated in the operational sections of this
specification is not implied. Exposure to absolute maximum rating
conditions for extended periods may affect reliability.
DC Electrical Characteristics for USB 2.0 Switching over Operating Range
(T_A = –40°C to +85°C, V_CC = 3.3V ±10%)
Paramenter
Description
Test
Conditions
Min.
V_IH
Input HIGH Voltage
Guaranteed HIGH level
2.0
V_IL
Input LOW Voltage
Guaranteed HIGH level
-5.0
V_IK
Clamp Diode Voltage
V_CC = Max., I_IN = –18mA
-
I_IH
Input HIGH Current
V_CC = Max., V_IN = VCC
-
I_IL
Input LOW Current
V_CC = Max., V_IN = GND
-
R_ON
Switch On-Resistance⁽³⁾
V_CC = Min., 1.25V ≤ V_IN ≤ V_CC,
I_IN = –40mA
-
R_FLAT(ON) On-Resistance Flatness⁽⁴⁾
V_CC = Min., V_IN @ 1.5V and
V_CC I_IN = -40mA
-
ΔR_ON
On-Resistance match from cen- V_CC = Min., 1.5V ≤ V_IN ≤ V_CC,
ter ports to any other port⁽⁴⁾
I_IN = -40mA
-
Type⁽²⁾ Max.
-
-
-
0.8
-0.7 -1.2
-
±5
-
±5
4
8
Units
V
μA
1.0
-
Ω
0.9
2
Capacitance (T_A = 25°C, f = 1MHz)
Parameters⁽⁴⁾
Description
Test Conditions Type
Max.
Units
C_IN
Input Capacitance
2.0
3.0
C_OFF
Port I Capacitance, Switch OFF
V_IN = 0V
4.0
6.0
pF
C_ON
Switch Capacitance, Switch ON
6.0
10.0
Notes:
1. For max. or min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V_CC = 3.3V, T_A = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and B pins at indicated current through the switch. ON-resistance is determined by the lower of the
voltages on the two (A & B) pins.
4. This parameter is determined by device characterization but is not production tested.
2
PS8718
07/23/04