PI3C3861-A Datasheet, PDF (2/2 Pages) Pericom Semiconductor Corporation – 2.5V/3.3V, High Bandwidth, Hot-Insertion,10-Bit, 2-Port, Bus Switch

PI3C3861-A
2.5V/3.3V, High-Bandwidth,
Hot-Insertion, 10 -Bit, 2-Port, Bus Switch
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ......................................................... –65°C to +150°C
Note:
Stresses greater than those listed under MAXIMUM
Ambient Temperature with Power Applied ........................ –40°C to +85°C RATINGS may cause permanent damage to the device.
Supply Voltage to Ground Potential (Inputs & Vcc Only) .. –0.5V to +4.6V ^{This is a stress rating only and functional operation}
of the device at these or any other conditions above
Supply Voltage to Ground Potential (Outputs & D/O Only)–0.5V to +4.6V those indicated in the operational sections of this
DC Input Voltage ................................................................. –0.5V to +5.5V ^{specificationisnotimplied.Exposuretoabsolutemaximumrat-}
ing conditions for extended periods may affect reliability.
DC Output Current............................................................................ 120mA
Power Dissipation ................................................................................ 0.5W
DC Electrical Characteristics (Over Operating Range, T_A = –40°C to +85°C, V_CC = 3.3V ±10%)
Parameters
Description
Test Conditions⁽¹⁾
Min. Typ⁽²⁾ Max.
V_IH
Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0
V_IL
Input LOW Voltage
Guaranteed Logic LOW Level
–0.5
0.8
I_IH
Input HIGH Current
V_CC = Max., V_IN = V_CC
±1
I_IL
Input LOW Current
V_CC = Max., V_IN = GND
±1
I_OZH
High Impedance Output Current 0 ≤ A, B ≤ V_CC
±1
V_IK
Clamp Diode Voltage
R_ON
Switch On-Resistance⁽³⁾
V_CC = Min., I_IN = –18mA
V_CC = Min., V_IN = 0V, I_ON = 48mA
V_CC = Min., V_IN = 2.4V,
I_ON = 15mA
–0.73 –1.2
5
7
8
15
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V_CC = 3.3V, T_A = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined
by the lower of the voltages on the two (A,B) pins.
Units
V
μA
V
Ω
Capacitance (T_A = 25°C, f = 1 MHz)
Parameters⁽¹⁾
Description
Test Conditions
Typ.
C_IN
Input Capacitance
6.0
C_OFF
C_ON
A/B Capacitance, Switch Off
A/B Capacitance, Switch On
V_IN = 0V
5.0
10.0
Notes:
1. This parameter is determined by device characterization but is not production tested.
Units
pF
06-0311
2
PS8880A
12/15/06