PI3C3384_11 Datasheet, PDF (2/5 Pages) Pericom Semiconductor Corporation – 2.5V/3.3V, High Bandwidth, Hot Insertion 10-Bit, 2-Port, Bus Switch

PI3C3384
2.5V/3.3V, High Bandwidth, Hot Insertion
10-Bit, 2-Port, Bus Switch
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature.................................................................... –65°C to +150°C
Ambient Temperature with Power Applied................................... –40°C to +85°C
Supply Voltage to Ground Potential (Input & V_CC Only).............. –0.5V to +4.6V
Supply Voltage to Ground Potential (Outputs & D/O Only).......... –0.5V to +4.6V
DC Input Voltage............................................................................–0.5V to +5.5V
DC Output Current...................................................................................... 120mA
Power Dissipation........................................................................................... 1.0W
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the device.
This is a stress rating only and functional operation
of the device at these or any other conditions above
those indicated in the operational sections of this
specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may
affect reliability.
DC Electrical Characteristics (Over Operating Range, T_A = –40°C to +85°C, V_CC = 3.3V ± 10%)
Parameters
Description
Test Conditions⁽¹⁾
Min Typ.⁽²⁾ Max
V_IH
V_IL
I_IH
I_IL
I_OZH
V_IK
R_ON
Input HIGH Voltage
Input LOW Voltage
Guaranteed Logic HIGH Level
Guaranteed Logic Low Level
Input HIGH Current
Input LOW Current
V_CC = Max, V_IN = V_CC
V_CC = Max, V_IN = GND
High-Impedance Output Current
0 ≤ A, B ≤ V_CC
Clamp Diode Voltage
Switch On Resistance⁽³⁾
V_CC = Min, I_IN = –18mA
V_CC = Min, V_IN = 0.0V
I_ON = 48mA or 64mA
V_CC = Min, V_IN = 0.0V
I_ON = 48mA or 64mA
2.0
–0.5
0.8
±1
±1
±1
–0.73 –1.2
5
7
8
15
Units
V
µA
V
Ω
Capacitance (T_A = 25°C, f = 1 MHz)
Parameters⁽⁴⁾
Description
Test Conditions
Typ.
Units
CIN
COFF
Input Capacitance
A/B Capacitance, Switch Off
V_IN = 0V
3.5
5.0
pF
CON
A/B Capacitance, Switch On
10.0
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determinedby the lower of the volt-
ages on the two (A,B) pins.
4. This parameter is determined by device characterization but is not production tested.
11-0008
2
PS8757G
11/25/10