PI3B3383 Datasheet, PDF (2/5 Pages) Pericom Semiconductor Corporation – 3.3V, 5-Bit, 4-Port Bus Exchange NanoSwitch

PI3B3383
3.3V, 5-Bit, 4-Port Bus Exchange
NanoSwitch^TM
1122334455667788990011223344556677889900112233445566778899001122112233445566778899001122334455667788990011223344556677889900112211223344556677889900112233445566778899001122334455667788990011221122334455667788990011223344556677889900112233445566778899001122112233445566778899001122
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Note:
Storage Temperature ........................................................ –65°C to +150°C _{Stresses greater than those listed under MAXIMUM}
Ambient Temperature with Power Applied ........................... –40°C to +85°C RATINGS may cause permanent damage to the device.
Supply Voltage to Ground Potential ...................................... –0.5Vto+4.6V ^{This is a stress rating only and functional operation of}
the device at these or any other conditions above those
DC Input Voltage ................................................................... –0.5Vto+4.6V _{indicated in the operational sections of this specifica-}
DC Output Current ............................................................................ 120mA tionisnotimplied. Exposuretoabsolutemaximumrating
Power Dissipation ................................................................................. 0.5W ^{conditions for extended periods may affect reliability.}
DC Electrical Characteristics (Over the Operating Range, T_A= –40°C to +85°C, V_CC = 3.3V ±10%)
Parameters
Description
Test Conditions⁽¹⁾
Min. Typ⁽²⁾
V_IH
Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0
—
V_IL
Input LOW Voltage
Guaranteed Logic LOW Level
–0.5
—
I_IH
Input HIGH Current
V_CC = Max., V_IN = V_CC
—
—
I_IL
Input LOW Current
V_CC = Max., V_IN = GND
—
—
I_OZH
High Impedance Output Current 0< AB, CD < V_CC
—
—
V_IK
Clamp Diode Voltage
V_CC = M_IN., I_IN = –18mA
—
–0.7
R_ON
Switch On Resistance⁽³⁾
V_CC = M_IN., V_IN = 0.0V, I_ON = 48mA
—
5
V_CC = M_IN., V_IN = 2.4V, I_ON = 15mA
—
10
Max.
—
0.8
±1
±1
±1
–1.2
7
15
Units
V
µA
V
Ω
Capacitance (T_A = 25°C, f = 1 MHz)
Parameters⁽⁴⁾
Description
Test Conditions
Typ.
Units
C_IN
C_OFF
C_ON
Input Capacitance
AB/CD Capacitance, Switch Off
AB/CD Capacitance, Switch On
V_IN = 0V
3.0
12.0
pF
24.0
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V_CC = 3.3V, T_A = 25°C ambient and maximum loading.
3. Measured by the voltage drop between AB and CD pin at indicated current through the switch. ON resistance is determined by
the lower of the voltages on the two (A or B, C or D) pins.
4. This parameter is determined by device characterization but is not production tested.
2
PS8580
10/18/01