PI3B3253LEX Datasheet, PDF (2/5 Pages) Pericom Semiconductor Corporation – 3.3V, Dual 4:1 Mux/DeMux NanoSwitch

PI3B3253
3.3V, Dual 4:1 Mux/DeMux NanoSwitch™
Maximum Ratings
(Above which the useful life may be impaired.For user guidelines, not tested.)
Storage Temperature...................................................................... –65°C to +150°C
Ambient Temperature with Power Applied..................................... –40°C to +85°C
Supply Voltage to Ground Potential ................................................–0.5V to +4.6V
DC Input Voltage..............................................................................–0.5V to +4.6V
DC Output Current........................................................................................ 120mA
Power Dissipation............................................................................................. 0.5W
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the de-
vice. This is a stress rating only and functional op-
eration of the device at these or any other conditions
above those indicated in the operational sections of
this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may
affect reliability.
DC Electrical Characteristics (Over the Operating Range, T_A = –40°C to +85°C, V_CC =3.3V ±10%)
Parameters
Description
       Test Conditions⁽¹⁾ Min. Typ.⁽²⁾ Max. Units
V_IH
V_IL
I_IH
I_IL
I_OZH
V_IK
R_ON
Input HIGH Voltage
Input LOW Voltage
Guaranteed Logic HIGH Level
2.0
Guaranteed Logic LOW Level
–0.5
V
0.8
Input HIGH Current
V_CC = Max., V_IN = V_CC
±1
Input LOW Current
V_CC = Max., V_IN = GND
±1
µA
High Impedance Output Current 0 ≤ I_N, Y_N ≤ V_CC
±1
Clamp Diode Voltage
V_CC = Min., I_IN = –18mA
–1.2
V
Switch On-Resistance⁽³⁾
V_CC = Min., V_IN = 0.0V,
I_ON = 48mA or 64mA
V_CC = Min., V_IN = 2.4V, I_ON = 15mA
5
8
Ω
10
17
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V_CC = 3.3V, T_A = 25°C ambient and maximum loading.
3. Measured by the voltage drop between I and Y pin at indicated current through the switch. On-Resistance is determined by the lower of the
voltages on the two (I,Y) pins.
Capacitance (T_A = 25°C, f = 1 MHz)
Parameters⁽¹⁾
Description
Test Conditions
C_IN
C_OFF
Input Capacitance
I_A/I_B Capacitance, Switch Off
V_IN = 0V
C_ON
I_A/I_B Capacitance, Switch On
Notes:
1. This parameter is determined by device characterization but is not production tested.
Typ.
3.0
8.0
36.0
Units
pF
11-0009
2
01/10/11