PI3B3253 Datasheet, PDF (2/5 Pages) Pericom Semiconductor Corporation – Mux/DeMux NanoSwitch™

PI3B3253
3.3V, Dual 4:1 Mux/DeMux NanoSwitch^™
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ..................................................................... –65°C to +150°C
Ambient Temperature with Power Applied .................................... –40°C to +85°C
Supply Voltage to Ground Potential ................................................–0.5V to +4.6V
DC Input Voltage .............................................................................–0.5V to +4.6V
DC Output Current........................................................................................ 120mA
Power Dissipation ............................................................................................ 0.5W
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the de-
vice. This is a stress rating only and functional op-
eration of the device at these or any other conditions
above those indicated in the operational sections of
this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may
affect reliability.
DC Electrical Characteristics (Over the Operating Range, T_A = –40°C to +85°C, V_CC =3.3V ±10%)
Parameters
Description
Test Conditions⁽¹⁾ Min. Typ.⁽²⁾
V_IH
Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0
V_IL
Input LOW Voltage
Guaranteed Logic LOW Level
–0.5
I_IH
Input HIGH Current
V_CC = Max., V_IN = V_CC
I_IL
Input LOW Current
V_CC = Max., V_IN = GND
I_OZH
High Impedance Output Current 0 ≤ I_N, Y_N ≤ V_CC
V_IK
Clamp Diode Voltage
V_CC = Min., I_IN = –18mA
V_CC = Min., V_IN = 0.0V,
R_ON
Switch On-Resistance⁽³⁾
I_ON = 48mA or 64mA
5
V_CC = Min., V_IN = 2.4V, I_ON = 15mA
10
Max.
0.8
±1
±1
±1
–1.2
8
17
Units
V
µA
V
Ω
Capacitance (T_A = 25°C, f = 1 MHz)
Parameters⁽⁴⁾
Description
Test Conditions
Typ.
Units
C_IN
C_OFF
C_ON
Input Capacitance
I_A/I_B Capacitance, Switch Off
I_A/I_B Capacitance, Switch On
V_IN = 0V
3.0
8.0
pF
36.0
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V_CC = 3.3V, T_A = 25°C ambient and maximum loading.
3. Measured by the voltage drop between I and Y pin at indicated current through the switch. On-Resistance is determined by the lower of the
voltages on the two (I,Y) pins.
4. This parameter is determined by device characterization but is not production tested.
2
PS8147G
09/09/04