PI3B16233AEX Datasheet, PDF (2/5 Pages) Pericom Semiconductor Corporation – 3.3V, 16-Bit to 32-Bit FET Mux/DeMux NanoSwitch™

PI3B16233
3.3V, 16-Bit to 32-Bit
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234^F56^E78^T90^M123^u45^x67^/8^D90^e1^M234^u56^x78^N90^a12ⁿ1^o23^S45^w67ⁱ8^t9^c0^h12
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ...................................................... –65°C to +150°C
Ambient Temperature with Power Applied ...................... –40°C to +85°C
Supply Voltage Range ....................................................... –0.5Vto+4.6V
DC Input Voltage ............................................................... –0.5Vto+4.6V
DC Output Current ........................................................................ 120mA
Power Dissipation ............................................................................. 0.5W
Note:
Stresses greater than those listed under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is a
stress rating only and functional operation of the device at these
or any other conditions above those indicated in the operational
sections of this specification is not implied. Exposure to
absolute maximum rating conditions for extended periods may
affect reliability.
DC Electrical Characteristics (Over the Operating Range, T_A = –40°C to +85°C, V_CC = 3.0V to 3.6V)
Parameters
Description
Test Conditions⁽¹⁾
Min. Typ.⁽²⁾ Max. Units
V_IH
Input HIGH Voltage
Guaranteed Logic High Level
V_IL
Input LOW Voltage
Guaranteed Logic Low Level
I_IH
Input HIGH Current
V_CC = Max., V_IN = V_CC
I_IL
Input LOW Current
V_CC = Max., V_IN = GND
I_OZH
High Impedance Output Current 0 ≤ A, B ≤ V_CC
2.0
V
–0.5
0.8
±1
±1 μA
±1
V_IK
Clamp Diode Voltage
R_ON
Switch ON Resistance⁽³⁾
V_CC = Min., I_IN = –18mA
V_CC = Min., V_IN = 0.0V, I_ON = 48mA or 64mA
V_CC = Min., V_IN = 2.4V, I_ON = 15mA
–0.7 –1.2 V
5
8
Ω
10
15
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V_CC = 3.3V, T_A = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determined
by the lower of the voltages on the two (A,B) pins.
Capacitance (T_A = 25°C, f = 1 MHz)
Parameters⁽¹⁾
Description
Test Conditions
C_IN
Input Capacitance
C_ON
A/B Capacitance, Switch On
V_IN = 0V
Notes:
1. This parameter is determined by device characterization but is not production tested.
Typ.
Units
3.0
pF
25.0
07-0010
2
PS8171F
05/09/06