PI3B16233 Datasheet, PDF (2/5 Pages) Pericom Semiconductor Corporation – 3.3V, 16-Bit to 32-Bit FET

PI3B16233
3.3V, 16-Bit to 32-Bit
12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345^F67^E89^T01^M234^u56^x7^/8^D90^e12^m34^u56^x78^N90^a12ⁿ1^o23^S45^w67ⁱ8^t9^c0^h12
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ...................................................... –65°C to +150°C
Ambient Temperature with Power Applied ...................... –40°C to +85°C
Supply Voltage Range ....................................................... –0.5Vto+4.6V
DC Input Voltage ............................................................... –0.5Vto+4.6V
DC Output Current ........................................................................ 120mA
Power Dissipation ............................................................................. 0.5W
Note:
Stresses greater than those listed under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is a
stress rating only and functional operation of the device at these
or any other conditions above those indicated in the operational
sections of this specification is not implied. Exposure to
absolute maximum rating conditions for extended periods may
affect reliability.
DC Electrical Characteristics (Over the Operating Range, T_A = –40°C to +85°C, V_CC = 3.0V to 3.6V)
Parameters
Description
Test Conditions⁽¹⁾
Min. Typ.⁽²⁾
V_IH
Input HIGH Voltage
Guaranteed Logic High Level
2.0
V_IL
Input LOW Voltage
Guaranteed Logic Low Level
–0.5
I_IH
Input HIGH Current
V_CC = Max.; V_IN = V_CC
I_IL
Input LOW Current
V_CC = Max.; V_IN = GND
I_OZH
High Impedance Output Current 0 ≤ A, B ≤ V_CC
V_IK
Clamp Diode Voltage
V_CC = Min, I_IN = –18mA
–0.7
R_ON
Switch ON Resistance⁽³⁾
V_CC = Min., V_IN = 0.0V, I_ON = 48mA or 64mA
5
V_CC = Min., V_IN = 2.4V, I_ON = 15mA
10
Max.
0.8
±1
±1
±1
–1.2
8
15
Units
V
µA
V
Ω
Capacitance (T_A = 25°C, f = 1 MHz)
Parameters⁽⁵⁾
Description
Test Conditions
Typ.
C_IN
Input Capacitance
C_ON
A/B Capacitance, Switch On
3.0
V_IN = 0V
25.0
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V_CC = 3.3V, T_A = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determined
by the lower of the voltages on the two (A,B) pins.
4. This parameter is determined by device characterization but is not production tested.
Units
pF
2
PS8171E
09/29/04