PI3B16232 Datasheet, PDF (2/3 Pages) Pericom Semiconductor Corporation – 3.3V, Synchronous 16-Bit to 32-Bit FET Mux/Demux BusSwitch

PI3B16232
3.3V, Synchronous 16-Bit to 32-Bit
FET Mux/Demux BusSwitch _{1122334455667788990011223344556677889900112233445566778899001122112233445566778899001122334455667788990011223344556677889900112211223344556677889900112233445566778899001122334455667788990011221122334455667788990011223344556677889900112233445566778899001122112233445566778899001122}
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ..................................................... –65°C to +150°C
Ambient Temperature with Power Applied .................... –40°C to +85°C
Supply Voltage Range ......................................................–0.5V to +4.6V
DC Input Voltage .............................................................–0.5V to +4.6V
DC Output Current ....................................................................... 120 mA
Power Dissipation ............................................................................. 0.5W
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the device.
This is a stress rating only and functional operation of
the device at these or any other conditions above those
indicated in the operational sections of this specification
is not implied. Exposure to absolute maximum rating
conditions for extended periods may affect reliability.
DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 3.0V to 3.6V)
Parameters Description
Test Conditions⁽¹⁾
Min. Typ⁽²⁾
VIH
Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0 —
VIL
Input LOW Voltage
Guaranteed Logic LOW Level
–0.5 —
IIH
Input HIGH Current
IIL
Input LOW Current
VCC = Max., VIN = VCC
VCC = MAX. , VIN = GND
—
——
IOZH
High Impedance Output Current 0 ≤ A, B ≤ VCC
——
VIK
Clamp Diode Voltage
VCC = Min.,VIN = –18mA
— -0.7
Ron
Switch on Resistance⁽³⁾
VCC = Min., IIN = 0.0V, ION = 48mA or 64mA —
5
VCC = Min.,VIN = 2.4 V, ION = 15mA
— 10
Max.
—
0.8
±1
±1
±1
-1.2
8
15
Units
V
V
µA
µA
µA
V
Ω
Ω
Capacitance (TA = 25°C, f = 1 MHz)
Parameters⁽⁴⁾ Description
Test Conditions
Typ.
Units
CIN
Input Capacitance
CON
A/B Capacitance, Switch On
VIN = 0V
VIN = 0V
3.0
pF
25.0
pF
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device.
2. Typical values are at Vcc = 3.3V, TA = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determined by the
lower of the voltages on the two (A,B) pins.
4. This parameter is determined by device characterization but is not production tested.
2
PS8178B 11/09/98