PI3B16210 Datasheet, PDF (2/3 Pages) Pericom Semiconductor Corporation – 3.3V, 20-Bit, 2-Port NanoSwitch™

PI3B16210/162210
11223344556677889900112233445566778899001122334455667788990011221122334455667788990011223344556677889900112233445566778899001122112233445566778899001122334455³6677^.88³99^V001122^,33^H445566^o77^t8899^I00ⁿ1122^s11^e22^r3344^t55ⁱ66^o77ⁿ8899^,0011²22⁰3344^-55^B6677ⁱ88^t99^,00²1122^-33^P4455^o66^r7788^t9900^B1122^u11^s2233^S44^w556677ⁱ88^t99^c00^h1122
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ................................................................. –65°C to +150°C
Ambient Temperature with Power Applied .................................. –0°C to +85°C
Supply Voltage Range .................................................................. –0.5V to +4.6V
DC Input Voltage ......................................................................... –0.5V to +4.6V
DC Output Current ................................................................................... 120 mA
Power Dissipation ......................................................................................... 0.5W
Note:
Stresses greater than those listed under
MAXIMUM RATINGS may cause permanent
damage to the device. This is a stress rating only and
functional operation of the device at these or any
other conditions above those indicated in the opera-
tional sections of this specification is not implied.
Exposure to absolute maximum rating conditions
for extended periods may affect reliability.
DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 3.0V to 3.6V)
Parameters Description
VIH
Input HIGH Voltage
VIL
Input LOW Voltage
II
Input Current
IOZH
High Impedance Output Current
VIK
Clamp Diode Voltage
RON
Switch On Resistance⁽³⁾
Test Conditions⁽¹⁾
Guaranteed Logic HIGH Level
Guaranteed Logic LOW Level
VCC = Max. VIN = VCC or GND
VCC = 0V, VIN = VCC
0 ≤ A, B ≤ VCC
VCC = Min, IIN = –18mA
VCC = 3V, VIN = 0.0V,
ION = 24 mA, 64mA
16210
162210
VCC = 3V, VIN = 2.4V,
ION = 15mA
16210
162210
Min.
2.0
–0.5
—
—
—
—
—
20
—
20
Typ⁽²⁾
—
—
—
—
—
–0.7
5
28
—
35
Max.
—
0.8
±1
±1
10
–1.2
8
40
15
48
Units
V
V
µA
µA
µA
V
Ω
Ω
Capacitance (TA = 25°C, f = 1 MHz)
Parameters⁽⁴⁾ Description
CIN
COFF
CON
Input Capacitance
A/B Capacitance, Switch OFF
A/B Capacitance, Switch ON
Test Conditions
VIN = 0V
VIN = 0V
VIN = 5V
Typ Units
3.0
8.5 pF
17.0
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at Vcc = 3.3V, TA = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determined by the
lower of the voltages on the two (A,B) pins.
4. This parameter is determined by device characterization but is not production tested.
2
PS8193B 11/09/98