PI3A212 Datasheet, PDF (2/8 Pages) Pericom Semiconductor Corporation – Small Plastic Package, Dual SPDT Analog Switch

PI3A212
Small Plastic Package, Dual SPDT Analog Switch
Absolute Maximum Ratings⁽¹⁾
Supply Voltage V_CC ........................................... –0.5V to 4.6V
DC Switch Voltage (V_S)⁽²⁾ ........................ –0.5V to V_CC +0.5V
DC Input Voltage (V_IN)⁽²⁾ .................................. –0.5V to 4.6V
Continuous Current NO_NC_COM_ .............................. ±300mA
Peak Current NO_NC_COM_
(pulsed at 1ms 50% duty cycle) ............................... ±400mA
Peak Current NO_NC_COM_
(pulsed at 1ms 10% duty cycle) ............................... ±500mA
Storage Temperature Range (T_STG) .............. –65°C to +150°C
Junction Temperature under Bias (T_J) .............................150°C
Junction Lead Temperature (T_L)
(Soldering, 10 seconds) ................................................260°C
Power Dissipation (P_D) @ +85°C .................................. 250mW
Recommended Operating Conditions⁽³⁾
Supply Voltage Operating (V_CC) . . . . . . . . 2.7V to 4.2V ±10%
Control Input Voltage (V_IN) . . . . . . . . . . . . . . . . . . . 0V to V_CC
Switch Input Voltage (V_IN) . . . . . . . . . . . . . . . . . . -0.3V to V_CC
Output Voltage (V_OUT) . . . . . . . . . . . . . . . . . . . . . . . 0V to V_CC
Operating Temperature (T_A) . . . . . . . . . . . . . . . –40°C to +85°C
Input Rise and Fall Time (t_r,t_f)
Control Input V_CC = 2.3V - 3.6V. . . . . . . . . 0ns/V to 10ns/V
Thermal Resistance (θ_JA) . . . . . . . . . . . . . . . . . . . . . . 350°C/W
Lead Temperature (soldering 10s) . . . . . . . . . . . . . . . . . +300°C
Bump Temperature (soldering notes)
Infared (15s). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +220°C
Vapor Phase (60ns) . . . . . . . . . . . . . . . . . . . . . . . . . . +215°C
Notes:
1. "Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any
other conditions beyond those indicated in the operational sections of this specification is not implied.
2. The input and output negative voltage ratings may be exceeded if the inut and output diode current ratings are observed.
3. Control input must be held HIGH or LOW; it must not float.
06-0096
2
PS8802E
07/06/06