PI74FCT16827 Datasheet, PDF (1/7 Pages) Pericom Semiconductor Corporation – Fast CMOS 20-Bit Buffers

PI74FCT1682_P7_IT₇/1₄6_F28_C27_T/1₁6₆2H₈₂82₇7_TT
PI74FCT162827T ^{123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012345678920102-3B45I67T89B012U12F34F56E78R90S12}
PI74FCT162H827T
1122334455667788990011223344556677889900112233445566778899001122112233445566778899001122334455667788990011223344556677889900112211223344556677889900112233445566778899001122334455667788990011221122334455667788990011223344556677889900112233445566778899001122112233445566778899001122
Product Features:
Fast CMOS
20-Bit Buffers
Common Features:
• PI74FCT16827T,PI74FCT162827T,andPI74FCT2H827T
are high-speed,
low power devices with high current drive
Product Description:
Pericom Semiconductor’s PI74FCT series of logic circuits are pro-
duced in the Company’s advanced 0.6 micron CMOS technology,
achieving industry leading speed grades.
• VCC =5V±10%
• Hysteresis on all inputs
• Packages available:
– 56-pin 240 mil wide plastic TSSOP (A)
– 56-pin 300 mil wide plastic SSOP (V)
PI74FCT16827T Features:
• High output drive: IOH = –32 mA; IOL = 64 mA
• Power off disable outputs permit "live insertion"
• Typical VOLP (Output Ground Bounce) < 1.0V
at VCC = 5V, TA = 25°C
PI74FCT162827T Features:
• Balanced output drivers: ±24 mA
• Reduced system switching noise
• Typical VOLP (Output Ground Bounce) < 0.6V
at VCC = 5V, TA = 25°C
PI74FCT162H827T Features:
The PI74FCT16827T, PI74FCT162827T, and PI74FCT162H827T are
20-bit wide bus drivers designed to provide buffering and high-
performance bus interfacing for wide data/address paths or buses
with parity. Two pair of nanded output enable controls allow the
devices to be operated as two 10-bit buffers or as one 20-bit buffer.
Signal pins are arranged in a flow-through organization for ease of
layout and hysteresis is designed into all inputs to improve noise
margin.
The PI74FCT16827T output buffers are designed with a Power-Off
disable function allowing “live insertion” of boards when the
devices are used as backplane drives.
The PI74FCT162827T has ±24 mA balanced output drivers. It is
designed with current limiting resistors at its outputs to control the
output edge rate resulting in lower ground bounce and undershoot.
This eliminates the need for external terminating resistors for most
interface applications.
The PI74FCT162H827T has “Bus Hold” which retains the input's last
state whenever the input goes to high-impedance preventing
“floating” inputs and eliminating the need for pull-up/down resistors.
• Bus Hold retains last active bus state during 3-state
• Eliminates the need for external pull-up resistors
Logic Block Diagram
1OE1
1OE2
2OE1
2OE2
1A1
1Y1
2A1
2Y1
To 9 other channels
To 9 other channels
1
PS2041A 03/11/96