PI74FCT162541 Datasheet, PDF (1/6 Pages) Pericom Semiconductor Corporation – Fast CMOS 16-Bit Octal Buffer/Line Drivers

PI74FCT16541/162541/162H541T
PPI7I47F4FCCTT11662554411TT ^{123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789011621-2B34I5T678B90U12F34F56E78R90/1L23I45N67E890D12R12I3V456E78R90S12}
PI74FCT162H541T
1122334455667788990011223344556677889900112233445566778899001122112233445566778899001122334455667788990011223344556677889900112211223344556677889900112233445566778899001122334455667788990011221122334455667788990011223344556677889900112233445566778899001122112233445566778899001122
Product Features
Common Features
• PI74FCT16541T, PI74FCT162541T, and
PI74FCT162H541T are high-speed,
low power devices with high current drive
• VCC = 5V ±10%
• Hysteresis on all inputs
• Packages available
– 48-pin 240 mil wide plastic TSSOP (A48)
– 48-pin 300 mil wide plastic SSOP (V48)
PI74FCT16541T Features
• High output drive: IOH = –32 mA; IOL = 64 mA
• Power off disable outputs permit “live insertion”
• Typical VOLP (Output Ground Bounce) < 1.0V
at VCC = 5V, TA = 25°C
PI74FCT162541T Features
• Balanced output drivers: ±24 mA
• Reduced system switching noise
• Typical VOLP (Output Ground Bounce) < 0.6V
at VCC = 5V, TA = 25°C
PI74FCT162H541T Features
• Bus Hold retains last active bus state during 3-state
• Eliminates the need for external pull-up resistors
Logic Block Diagram
Fast CMOS 16-Bit Octal
Buffer/Line Drivers
Product Description
Pericom Semiconductor’s PI74FCT series of logic circuits are pro-
duced in the Company’s advanced 0.6/0.8 micron CMOS technology,
achieving industry leading speed grades.
The PI74FCT16541T, PI74FCT162541T, and PI74FCT162H541T
are non-inverting 16-bit buffer/line drivers designed for applications
driving high capacitance loads and low impedance backplanes.
These high-speed, low-power devices offer bus/backplane interface
capability and a flow-through organization for ease of board layout.
They are designed with three-state controls to operate in a Dual-
Byte, or a single 16-bit word mode.
The PI74FCT16541T output buffers are designed with a Power-
Off disable allowing “live insertion” of boards when used as
backplane drivers.
The PI74FCT162541T has ±24 mA balanced output drivers. It is
designed with current limiting resistors at its outputs to control the
output edge rate resulting in lower ground bounce and undershoot.
This eliminates the need for external terminating resistors for most
interface applications.
The PI74FCT162H541T has “Bus Hold” which retains the input’s
last state whenever the input goes to high-impedance preventing
“floating” inputs and eliminating the need for pull-up/down resistors.
1OEA
1OEB
2OEA
2OEB
1A0
1Y0
2A0
2Y0
1A1
1Y1
2A1
2Y1
1A2
1Y2
2A2
2Y2
1A3
1Y3
2A3
2Y3
1A4
1Y4
2A4
2Y4
1A5
1Y5
2A5
2Y5
1A6
1Y6
2A6
2Y6
1A7
1Y7
2A7
2Y7
229
PS2037A 03/11/96