PE3503 Datasheet, PDF (5/7 Pages) Peregrine Semiconductor Corp. – 3500 MHz Low Power UltraCMOS™ Divide-by-8 Prescaler

PE3503
Product Specification
Evaluation Kit
Evaluation Kit Operation
The MSOP Prescaler Evaluation Board was designed
to help customers evaluate the PE3503 Divide-by-8
Prescaler. On this board, the device input (pin 2) is
connected to connector J1 through a 50 Ω transmission
line. A series capacitor (C3) provides the necessary
DC block for the device input. It is important to note
that the value of this capacitance will impact the
performance of the device. A value of 15 pF was found
to be optimal for this board layout; other applications
may require a different value.
The device output (pin 7) is connected to connector J3
through a 50 Ω transmission line. A series capacitor
(C1) provides the necessary DC block for the device
output. Note that this capacitor must be chosen to
have a low impedance at the desired output frequency
the device. The value of 100 pF was chosen to provide
a wide operating range for the evaluation board.
The board is constructed of a two-layer FR4 material
with a total thickness of 0.031”. The bottom layer
provides ground for the RF transmission lines. The
transmission lines were designed using a coplanar
waveguide above ground plane model with trace width
of 0.030”, trace gaps of 0.007”, dielectric thickness of
0.028”, metal thickness of 0.0014” and ε_r of 4.4. Note
that the predominate mode for these transmission lines
is coplanar waveguide. J2 provides DC power to the
device. Starting from the lower left pin, the second pin
to the right (J2-3) is connected to the device V_DD pin
(1). Two decoupling capacitors (10 pF, 1000 pF) are
included on this trace. It is the responsibility of the
customer to determine proper supply decoupling for
their design application.
The DEC pin (3) must be connected to a low
impedance AC ground for proper device operation. On
the board, two decoupling capacitors (C6 = 10 nF, C4 =
10 pF), located on the back of the board, perform this
function.
Applications Support
If you have a problem with your evaluation kit or if you
have applications questions call [phone] and
ask for applications support. You may also contact us
by fax or e-mail:
Fax: [phone]
E-Mail: [e-mail]
Figure 9. Evaluation Board Layouts
Peregrine Specification 101/0035
Figure 10. Evaluation Board Schematic
Peregrine Specification 102/0055
Document No. 70-0050-04 │ www.psemi.com
©2005 Peregrine Semiconductor Corp. All rights reserved.
Page 5 of 7