P6CU_14 Datasheet, PDF (4/4 Pages) PEAK electronics GmbH – PM1-SERIES

Package / Pinning / Derating
2.1
(0.9)
0.50
(0.02)
19.50
(0.76)
0.50
(0.02)
PEAK
Modelcode
12
4
Datecode
5 67
2.54
(0.10)
15.24
(0.60)
All dimensions are typical in millimeters (inches).
- Pin diameter: 0.5 +/-0.05 (0.02 +/-0.002)
- Pin pitch tolerance: +/-0.35 (+/-0.014)
- Case tolerance +/-0.5 (+/-0.02)
Specification may change without notice.
6.00*
(0.24)
* The thickness
of 48Vin voltage
is 7.20(0.28)
SIP 7 – PLASTIC CASE
PIN CONNECTIONS
# SINGLE DUAL
1 +Vin
+Vin
2 - Vin
- Vin
4 - Vout - Vout
5 Omitted Common
6 +Vout +Vout
7 Omitted Omitted
App Notes:
¹ = Measured Input reflected ripple current with a simulated source inductance of 12uH.
² = Tested by minimal Vin and constant resistive load.
- Operation under no-load conditions will not damage these devices, but they will not observe the listed specifications.
- For reduce converter’s ripple & noise, it is recommended to add a 4.7µF~100µF(±4.7µF~±68µF for dual output) capacitor in
output end. For EMI performance improvement, it is recommended to add a 12µH inductor and a 10µF~100µF capacitor in input
end.
Radiated
Emissions
ESD
RS
EMC SPECIFICATIONS
EN 55022
CLASS B
FCC 47CFR Part 15/A
CLASS B
IEC 61000-4-2
Perf. Criteria B
IEC 61000-4-3
Perf. Criteria A
PM1-Series – P6CU-xxxxE/Z LF – Single and Dual Output – SIP7 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 4/4