PD6NG-053R3E21H30 Datasheet, PDF (3/3 Pages) PEAK electronics GmbH – PD6NG-XXXXE2:1H30 3KV ISOLATED 1W REGULATED SINGLE OUTPUT SIP8

PD6NG-XXXXE2:1H30 3KV ISOLATED 1W REGULATED SINGLE OUTPUT SIP8
External capacitance:
These converters will work with without external
capacitors but they are necessary in order to
guarantee the full line load range. All parts have
been tested using the following recommended
values.
+ Vin
＋
Cin
- Vin
Converter
+ Vout
＋
Cout
- Vout
Cin
Cout
10uF/100V, low ESR.
100uF/25V, low ESR.
Pin 3 (CTRL)
Control pin (ON/OFF)
Output starts at low or open and stops when high.
Voltage applied via a limiting resistor and switching
diode. The converter is in a low power mode during
the high level phase.
Connection example
1K
MCU
Vcc-5V
1N4148
PIN 3
CONVERTER
Pin 8 (CS)
This pin provides a connection point to the main
reservoir capacitor. Additional capacitance can
be added from this to pin 7. Any low ESR
capacitor will improve ripple and noise in some
measure. Starting values can be in the range of
100uF.
Pin 5 (NE)
This pin is used internally and must have have no external connection.
Application Notes
Pin 3: The outside control connection. This pin provides the converter output ON/OFF,
and the control common is referred to negative input.
Pin 5: This pin belongs to the secondary side. It just avoids someone to reverses the primary
and secondary.
Pin 8: Max. 1000 uF
Specification can be changed without notice.
REV: 1 / 03.2003
Copyright PEAK electronics GmbH