DCA55T Datasheet, PDF (22/26 Pages) PEAK electronics GmbH – PEAK ATLAS DCA SEMICONDUCTOR COMPONENT ANALYSER

Atlas DCA User Guide
Care of your Atlas DCA
October 2007 – Rev 7
The Peak Atlas DCA should provide many years of service if used in
accordance with this user guide. Care should be taken not to expose your unit
to excessive heat, shock or moisture. Additionally, the battery should be
replaced at least every 12 months to reduce the risk of leak damage.
If a low battery warning message
appears, immediate replacement of the
battery is recommended as measured
parameters may be affected. The unit
may however continue to operate.
* Low Battery *
The battery can be replaced by carefully opening the Atlas DCA by removing
the three screws from the rear of the unit. Take care not to damage the
electronics.
The battery should only be replaced with a high quality battery identical to, or
equivalent to an Alkaline GP23A or MN21 12V (10mm diameter x 28mm
length). Replacement batteries are available directly from Peak Electronic
Design Limited and many good electronic/automotive outlets.
Page 22