PPM26-H-3R3ELF Datasheet, PDF (1/4 Pages) PEAK electronics GmbH – PPM-SERIES

PPM40-H-xxELF
PPM-SERIES
Rev.03-2013
40 Watt
Univ. 85-264VAC (120-370VDC)
Single Output
Over Voltage Protection (out)
3 kV AC I/O Isolation
Low Ripple and Noise
High Efficiency
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. [phone]
Fax: [phone]
www.peak-electronics.de
[e-mail]
The PPM-Series are high efficiency green power moduls with various
packaging provided by Peak. The features of this series are: wide input
voltage, DC and AC all in one, high efficiency, high reliability, low loss, safety
isolation etc. They are widely used in industrial, office and civil equipments.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Input Voltage Range
Input Frequency
Input Current
Inrush Current
85 – 264 VAC or 120 – 370 VDC universal
47 – 440 Hz
115 VAC at 0.86A, max ; 230 VAC at 0.46A, max
115 VAC at 30A, max ; 230 VAC at 50A, max
Output Specifications
Voltage Accuracy
Line Regulation (full load)
Load Regulation (10-100%)
Ripple and Noise (20Mhz bandwidth)
Short Circuit Protection
Over Current Protection
Over Voltage Protection
Min Load
Trim
±2%
±0.5%
±1%
3.3, 5 Vout - 50mV pk-pk, typ
12, 24 Vout - 100mV pk-pk, typ
Continuous, auto resume
110-150% , auto resume
Zener Diode Clamp
1%
10%
Common Specifications
Temperature range
Storage
Hold up Time
Humidity
Altitude
Switching Frequency
I/O Isolation Voltage
Safety Standards
Safety Approvals
Safety Class
Hot swap
Case Material
Install
Cooling
Reliability Calculated MTBF (MIL-HDBK-217F)
Weight
-40°C to +70 °C
-40°C to +85 °C
15mS, typ. at 115VAC 80mS, typ at 230VAC
95%, max.
2000m, max
65kHz, typ
3000VAC / 1min.
IEC60950, EN60950, UL60950
pending
CLASS II
Forbid
UL94V-0 rated
PCB
Free air convection
> 200,000 hrs
~ 250g
PPM-Series – PPM40-H-xxELF – Single Output - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/4