PEN5_14 Datasheet, PDF (1/3 Pages) PEAK electronics GmbH – PEN-SERIES

PEN5-xxxxE/Z2:1LF
PEN-SERIES
Rev.09-2009
4-6 Watt
2:1 Wide Input
Reg. Single and Dual Output
DIP24 Metal Case
1.5 kV DC I/O Isolation
Continuous Short Circuit Prot.
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. [phone]
Fax: [phone]
www.peak-electronics.de
[e-mail]
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
2:1 Wide Input
Pi Type
35 mA pk-pk
Output Specifications
Voltage Accuracy
Short Circuit Protection
Line Regulation
Load Regulation
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
± 1%
Indefinite (automatic recovery)
± 0.5%
± 0.5% / ± 1.5% (only 3.3 / ±3.3 Vout Models)
60 mV pk-pk
± 0.02% / °C
General Specifications
Efficiency
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacity
I/O Isolation Resistance
Switching Frequency (typical)
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F)
See Table
1500 VDC
470 pF, typ.
1000 MOhm
266 kHz, typ.
95% rel H
> 1.121 Mhrs
Physical Specifications
Case Material
Potting Material
Weight
Nickel Coated Copper
Epoxy (UL94V-0 rated)
~ 17g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
RoHS Conform
-40 to +85°C (ambient)
100°C
-40 to +125°C
Free Air Convection (10mm distance required)
Soldering 260°C, max. (1.5mm from case 10s.)
PEN-Series – PEN5-xxxxE/Z2:1LF – Single and Dual Output – DIP24 - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/3