P6MG_14 Datasheet, PDF (1/3 Pages) PEAK electronics GmbH – PM4-SERIES

P6MG-xxxxELF
PM4-SERIES
Rev.11-2008
1 Watt
Regulated
Single Output
DIP14 Case
3 kV DC I/O Isolation
Low Ripple and Noise
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. [phone]
Fax: [phone]
www.peak-electronics.de
[e-mail]
The PM4 series P6MG-xxxxELF is a family of cost effective 1 W regulated
single output DC/DC converters. These converters are in an ultra miniature
DIP14 case. Devices are encapsulated. High performance features:
Regulated Output, 3000VDC input/output isolation, high efficiency
operation, output voltage accuracy of ±2% maximum, input range of ±10%
tolerance and low output ripple and noise.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
± 10%
Capacitors
20 mA pk-pk
Output Specifications
Voltage Accuracy
Short Circuit Protection
Line Regulation
Load Regulation (0% - 100%)
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
± 2%
Short Term
± 0.5%
± 0.5% (3.3Vout Models: ± 1.0%)
50 mV pk-pk
± 0.02% / °C
General Specifications
Efficiency
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacity
I/O Isolation Resistance
Switching Frequency
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F)
See Table
3000 VDC
60 pF, typ.
1000 MOhm
50 kHz (Variable)
95% rel H
> 4.261 Mhrs
Physical Specifications
Case Material
Potting Material
Weight
Non Conductive Black Plastic (UL94V-0 rated)
Epoxy (UL94V-0 rated)
~ 2.7g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
RoHS Conform
-40 to +85°C (ambient)
100°C
-40 to +125°C
Free Air Convection
Soldering 260°C, max. (1.5mm from case 10s.)
PM4-Series – P6MG-xxxxELF – Single Output – DIP14 – 3KV - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/3