English
Language : 

P44TG_14 Datasheet, PDF (1/3 Pages) PEAK electronics GmbH – PMU-SERIES
P44TG-xxxxE/Z2:1MLF
PMU-SERIES
Rev.11-2008
12 Watt
Regulated
DIP24 Metal Case
1.5 kV DC I/O Isolation
Single and Dual Output
Continuous Short Circuit Prot.
Remote On / Off
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. +49 6135 7026-0
Fax: +49 6135 931070
www.peak-electronics.de
peak@peak-electronics.de
The PMU series are cost effective 12 W single & dual output DC/DC
converters. These converters are encapsulated in nickel-coated copper
DIP24 case with high performance features: Synchronous rectification, high
efficiency and tight line / load regulation.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current
2:1 Wide Input
Pi Type
20 mA pk-pk
Output Specifications
Voltage Accuracy
Short Circuit Protection
Over Current Protection
Line Regulation
Load Regulation (0% - 100%)
Cross Regulation (Dual Output)
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
Transient Recovery Time¹
Transient Response Deviation¹
± 1.2%
Indefinite (hiccup / automatic recovery)
150% of FL, typ.
± 0.5%, max.
± 0.5%, max. (Single) / ± 1%, max. (Dual)
± 5%
85 mV pk-pk
± 0.02% / °C
250us, typ.
± 3%, max.
General Specifications
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacity
I/O Isolation Resistance
Switching Frequency (typical)
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F)
1500 VDC
1200 pF, typ.
1000 M Ohm
330 kHz, typ.
95% rel H
> 1 Mhrs
Physical Specifications
Case Material
Potting Material
Weight
Nickel Coated Copper
Epoxy (UL94V-0 rated)
~ 18.0g, typ.
Environment Specifications
Operating Temperature
-40 to +60°C (ambient)
Maximum Case Temperature
100°C
Storage Temperature
-40 to +125°C
Cooling
Free Air Convection
RoHS Conform
Soldering 260°C, max. (1.5mm from case 10s.)
PMU-Series – P44TG-xxxxE/Z2:1LF – Single and Dual Output – DIP24 - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/3