P42TG_14 Datasheet, PDF (1/3 Pages) PEAK electronics GmbH – PMD-SERIES

P42TG-xxxxE/Z2:1MLF
PMD-SERIES
Rev.11-2008
10 Watt
Regulated
Single and Dual Output
1.5 kV DC I/O Isolation
DIP24 Metal Case
Continuous Short Circuit Prot.
Full SMD Technology
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. [phone]
Fax: [phone]
www.peak-electronics.de
[e-mail]
The PMD 10W series P42TG-xxxxE/Z2:1MLF is a family of cost effective
10W single & dual output DC-DC converters. These converters are
encapsulated in miniature DIP24 metal case. High performance features:
1500VDC input/output isolation, continuous short circuit protection with
automatic restart and tight line / load regulation, high efficiency operation,
output voltage accuracy of ±1% maximum. And a wide input of 2:1
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
Start Up Time (nom. Vin and constant resistive load)
2:1 Wide Input
Pi Type
20 mA pk-pk
20mS, typ.
Output Specifications
Voltage Accuracy
Short Circuit Protection
Line Regulation²
Load Regulation³ (Io = 10 - 100%)
Cross Regulation³ (Dual Output)
Over Current Protection
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
Transient Recovery Time⁴
Transient Response Deviation⁴
± 1%
Indefinite (hiccup, automatic recovery)
± 0.5%
± 0.5% (2.5, 3.3Vout Models: ± 0.7%)
± 5%
150% of FL, typ.
75 mV pk-pk
± 0.02% / °C
200us, typ
± 3%, max.
General Specifications
Efficiency
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacity
I/O Isolation Resistance
Switching Frequency (typical)
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F)
See Table
1500 VDC
1000 pF, typ.
1000 MOhm
330 kHz
95% rel H
> 1 Mhrs
Physical Specifications
Case Material
Potting Material
Weight
Nickel Coated Copper
Epoxy (UL94V-0 rated)
~ 17.0g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
RoHS Conform
-40 to +60°C (ambient)
100°C
-40 to +125°C
Free Air Convection
Soldering 260°C, max. (1.5mm from case 10s.)
PMD-Series – P42TG-xxxxE/Z2:1MLF – Single and Dual Output – DIP24 - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/3