P30WG_14 Datasheet, PDF (1/4 Pages) PEAK electronics GmbH – PMTW-SERIES

P30WG-xxxxE/Z/D4:1LF
Mainzer Straße 151–153
D-55299 Nackenheim
PMTW-SERIES
30 Watt
Rev.11-2009
Tel. [phone]
Fax: [phone]
www.peak-electronics.de
4:1 Ultra Wide Input
[e-mail]
2” x 1” Metal Case
1.6 kV DC I/O Isolation
Regulated Output
Single, Dual and Triple Output
Continuous Short Circuit Prot.
The PMTW series P30WG-xxxxE/Z/D4:1LF is a family of cost effective
30W, single, dual and triple output DC-DC converters with an ultra wide
input range of 4:1. These converters are encapsulated in nickel coated
brass 2”x1” case with high performance features: 1600VDC input/output
isolation voltage, continuous short circuit protection with automatic restart
and tight line / load regulation, over current protection, over voltage
protection, over temperature protection, high efficiency operation and soft
start.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
Start up Time (Nom. Vin and constant resistive load)
4:1 Ultra Wide Input (see table)
PI Type
20 mA pk-pk
30mS, typ.
Output Specifications
Voltage Accuracy
Voltage Adjustability (only Single Output)
Short Circuit Protection
Over Load Protection
Line Regulation
Load Regulation (0% - 100%) / Triple (10% - 100%)
Cross Regulation³
Ripple&Noise (20Mhz bandwidth / 1.0uF – pk-pk)
Temperature Coefficient
Transient Recovery Time⁴
Transient Response Deviation⁴
± 1% (main out) ± 5% (AUX - for triple output)
± 10%, max.
Indefinite (hiccup, automatic recovery)
150% of FL, typ.
± 0.5% (single&dual) ±1% / ±5% (triple main / aux)
± 0.5% (single) ±1% / ±5% (dual & triple main / aux)
± 5% (dual & triple)
100 mV (single&dual) 50 / 75mV (triple: main / aux)
± 0.02% / °C
250us, typ.
± 3%, max.
General Specifications
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacitance
I/O Isolation Resistance
Switching Frequency
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F)
1600 VDC
1500 pF, typ.
1000 M Ohm, min.
330 kHz, typ.
95% rel H
>435 khrs (single&dual out) >320 khrs (triple out)
Physical Specifications
Case Material
Potting / Base Material
Weight
Nickel Coated Copper
Epoxy / Plastic (UL94V-0 rated)
~ 31g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
RoHS Conform
-40 to +50°C (for 100% - ambient)
105°C
-40 to +125°C
Free Air Convection (10mm distance required)
Soldering 260°C, max. (1.5mm from case 10s.)
PMTW-Series – P30WG-xxxxE/Z/D 4:1LF – Single, Dual and Triple Output – 2”x1” - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/4