P18TG-123R3E21MLF Datasheet, PDF (1/3 Pages) PEAK electronics GmbH – PMD-SERIES

P18TG-xxxxE/Z2:1(H35)MLF
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. [phone]
PMD-SERIES
4 Watt
Regulated
Rev.11-2008
Fax: [phone]
www.peak-electronics.de
[e-mail]
DIP24 Metal Case
1.5 to 3.5 kV DC I/O Isolation
SINGLE and DUAL Output
Continuous Short Circuit Prot.
Full SMD Technology
The PMD 4W series P18TG-xxxxE/Z2:1(H35)MLF is a family of cost
effective 4W single & dual output DC-DC converters. These converters are
encapsulated in miniature DIP24 metal case. High performance features:
1500VDC up to 3500VDC input/output isolation, continuous short circuit
protection with automatic restart and tight line / load regulation, high
efficiency operation, output voltage accuracy of ±1% maximum and a wide
input range of 2:1
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
2:1 Wide Input
Pi Type
35 mA pk-pk
Output Specifications
Voltage Accuracy
Short Circuit Protection
Line Regulation
Load Regulation
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
± 1%
Indefinite (automatic recovery)
± 0.5%
± 0.5% (3.3 / ± 3.3Vout Models: ± 1.5%)
60 mV pk-pk
± 0.02% / °C
General Specifications
Efficiency
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacity
I/O Isolation Resistance
Switching Frequency (typical)
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F)
See Table
1500 VDC (3500 VDC optional)*
470 pF, typ.
1000 MOhm
266 kHz
95% rel H
> 1.121 Mhrs
Physical Specifications
Case Material
Potting Material
Weight
Nickel Coated Copper
Epoxy (UL94V-0 rated)
~ 17g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
RoHS Conform
-40 to +85°C (ambient)
100°C
-40 to +125°C
Free Air Convection
Soldering 260°C, max. (1.5mm from case 10s.)
PMD-Series – P18TG-xxxxE/Z2:1(H35)MLF – Single and Dual Output – DIP24 - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/3