P15VG_14 Datasheet, PDF (1/3 Pages) PEAK electronics GmbH – PMNW-SERIES

P15VG-xxxxE/Z4:1LF
PMNW-SERIES
Rev.08-2009
15 Watt
4:1 Wide Input
1” x 1” Case
1.6 kV DC I/O Isolation
Reg. Single and Dual Output
Remote ON/OFF Control
Continuous Short Circuit Prot.
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. [phone]
Fax: [phone]
www.peak-electronics.de
[e-mail]
The PMNW series is a family of high performance 15W single & dual output
DC-DC converters. These are encapsulated in nickel coated copper 1” x 1”
case with non conductive base.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
4:1 Wide Input (see table)
Pi-Type
Output Specifications
Voltage Accuracy
Short Circuit Protection
Output Voltage Adjustable (trim)
Cross Regulation¹ (dual output)
Line Regulation
Load Regulation (0% - 100%)
Ripple and Noise (20Mhz bandwidth)
Transient Recovery²
Transient Response Deviation²
Temperature Coefficient
± 1%, max.
Indefinite (hiccup, automatic recovery)
± 10%, max. (only single output)
± 5%
± 0.2%, max.
± 0.5%, max. (single) ± 1%, max. (dual)
100 mV pk-pk, max.
250 us, typ.
± 3%, max.
± 0.02% / °C, max.
General Specifications
Efficiency
I/O Isolation Voltage (3 sec.)
I/O Isolation Resistance
Switching Frequency
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F)
See Table
1600 VDC
1000 MOhm, min.
375 kHz, typ.
95% rel H
> 560 khrs
Physical Specifications
Case Material
Weight
Nickel Coated Copper
~ 18 g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
RoHS Conform
-40 to +66°C (for 100%)
105°C
-40 to +125°C
Free Air Convection (10 mm distance required)
Soldering 260°C, max. (1.5mm from case 10s.)
PMNW-Series – P15VG-xxxxE/Z 4:1LF – Single and Dual Output – 1”x1” - Metal Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/3