P10RG_14 Datasheet, PDF (1/4 Pages) PEAK electronics GmbH – PMBW-SERIES

P10RG-xxxxE/Z4:1LF
PMBW-SERIES
Rev.04-2009
2 Watt
4:1 Ultra Wide Input
Reg. Single and Dual Output
1.5 kV DC I/O Isolation
SIP9 case
On/Off Control
Contin. Short Circuit Protection
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. [phone]
Fax: [phone]
www.peak-electronics.de
[e-mail]
The PMBW 2Watt series is a family of cost effective DCDC converters with
4:1 ultra wide input, 2W single and dual output DC/DC converters with
control Pin. These converters are encapsulated in an ultra miniature SIP9
plastic case. High performance features: continuous / long time short circuit
protection with automatic restart and tight line / load regulation, high
efficiency operation and output voltage accuracy of ±2% maximum.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
Start-up Time
4:1 Ultra Wide Input (see table)
Capacitor
20 mA pk-pk
10 mS, typ.
Output Specifications
Voltage Accuracy
Short Circuit Protection
Line Regulation
Load Regulation (0% - 100%)
Cross Regulation (Dual Output)
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
Transient Recovery Time³
Transient Response Deviation³
± 1%
Indefinite (hiccup, Automatic Recovery)
± 0.5%
± 0.5%, max.(<10% load: ±1% for 3.3Vout and 5Vout)
± 5%
50 mV pk-pk
± 0.02% / °C
300 us, typ.
± 3%, max.
General Specifications
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacity
I/O Isolation Resistance
Switching Frequency
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F)
1500 VDC
500 pF, max.
1000 M Ohm
250 kHz
95% rel H
> 1.212 Mhrs
Physical Specifications
Case Material
Potting Material
Weight
Non Conductive Black Plastic (UL94V-0 rated)
Epoxy (UL94V-0 rated)
~ 6.5 g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
RoHS Conform
-40 to +75°C (ambient)
100°C
-40 to +125°C
Free Air Convection (10mm distance required)
Soldering 260°C, max. (1.5mm from case 10s.)
PMBW-Series – P10RG-xxxxE/Z4:1LF – Single / Dual Output – SIP9 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/4