EPA3940-12_15 Datasheet, PDF (1/1 Pages) PCA ELECTRONICS INC. – SO SMD 14 Pin Single Output Fast TTL Compatible Active Delay Line

ELECTRONICS INC.
SO SMD 14 Pin Single Output Fast
TTL Compatible Active Delay Line
EPA3940-12 & EPA3940-RC
Add “-RC” after part number for RoHS Compliant
Output
12 nS ± 1 nS
• Delay Times referenced from input to leading edges at 25°C, 5.0 V •
DC Electrical Characteristics
Parameter
Test Conditions
Min
VOH High-Level Output Voltage VCC= min. VIL= max. IOH = max 2.7
VOL Low-Level Output Voltage VCC= min. VIH = min. IOL= max
VIK Input Clamp Voltage
IIH High-Level Input Current
VCC= min. II = IIK
VCC = max. VIN = 2.7V
IIL Low-Level Input Current
VCC = max. VIN = 0.5V
IOS Short Circuit Output Current VCC= max. VOUT = 0.
-60
ICCH High-Level Supply Current VCC= max. VIN = OPEN
ICCL Low-Level Supply Current VCC= max. VIN = 0
TRO Output Rise Time
Td ≤ 500 nS (0.75 to 2.4 Volts)
NH Fanout High-Level Output VCC= max. VOH = 2.7V
NL Fanout Low-Level Output VCC= max. VOL = 0.5V
Max Unit
V
0.5 V
-1.2 V
20 µA
-0.6 mA
-150 mA
25 mA
40 mA
4
nS
20 TTL LOAD
10 TTL LOAD
Schematic
14
VCC
INPUT 1
7 GROUND
8 OUTPUT
Recommended
Operating Conditions
VCC
VIH
VIL
IIK
IOH
IOL
Supply Voltage
High-Level Input Voltage
Low-Level Input Voltage
Input Clamp Current
High-Level Output Current
Low-Level Output Current
Min
4.75
2.0
Max
5.25
0.8
-18
-1.0
20
Unit
V
V
V
mA
mA
mA
Package
.024
(.610)
Pin 1
I.D.
PCA
.200
EPA3940-12(-RC)
D.C.
(5.08)
.300
(7.62)
.060
(1.52)
.155 _.275
(3.94) _(6.99)
Suggested Solder
Pad Layout
Input Pulse Test Conditions @ 25° C
EIN
PW
TRI
PRR
VCC
Pulse Input Voltage
Pulse Width
Pulse Rise Time (0.75 - 2.4 Volts)
Pulse Repetition Rate
Supply Voltage
Unit
3.2 Volts
12 nS
2.0 nS
20 MHz
5.0 Volts
.235
(5.97)
.500
(12.70)
.004 Typ.
(.102)
0°-8°
.008/.012
(.203/.305)
.018/.022
(.457/.559)
.228/.244
(5.79/6.20)
Notes :
1. Assembly Process
(Solder Composition)
(Leadframe)
(Assembly Solder)
EPA3940-12
SnPb
SnPb
2. Peak Solder Rating
(per IPC/JEDEC-J-STD-020C)
3. Moisture Sensitive Levels (MSL)
(per IPC/JEDEC-J-STD-020C)
4. Weight
5. Packaging Information
(Tube)
(*Add “TR” to end of part number
when placing order)
(Tape & Reel)
260°C
10 (+2/-0) seconds
3
(168 hours,
≤30°C/60%RH)
TBD grams
44 pieces/tube
TBD pieces/13” reel
(*EPA3940-12-TR)
EPA3940-12-RC
Sn
SnPb
(RoHS exemption 7a)
260°C
10 (+2/-0) seconds
4
(72 hours,
≤30°C/60%RH)
TBD grams
44 pieces/tube
TBD pieces/13” reel
(*EPA3940-12-RCTR)
PCA ELECTRONICS, INC.
16799 SCHOENBORN ST.
NORTH HILLS, CA 91343
Unless Otherwise Specified Dimensions are in Inches /mm ± .010 /.25
Product performance is limited to specified parameters. Data is subject to change without prior notice.
CSA3940-12 & -RC Rev. 1 12/20/05 RR
TEL: [phone]
FAX: [phone]
http://www.pca.com