EPA3507-25 Datasheet, PDF (1/1 Pages) PCA ELECTRONICS INC. – 14 Pin DIP and SMD 5 Tap Both Edges Controlled Fast Logic TTL Compatible Active Delay Lines

14 Pin DIP and SMD 5 Tap Both Edges Controlled
Fast Logic TTL Compatible Active Delay Lines
Compatible with standard auto-insertable equipment and can be used in either infrared or vapor phase process.
Input to Tap ± 5% or ± 2nS†
Tap to Tap ± 7% or ± 2nS†
Tap
Total
DIP Part
Number
SMD Part
Number
Input to Tap ± 5% or ± 2nS†
Tap to Tap ± 7% or ± 2nS†
Tap
Total
DIP Part
Number
5, 10, 15, 20
6, 12, 18, 24
7, 14, 21, 28
8, 16, 24, 32
9, 18, 27, 36
10, 20, 30, 40
12, 24, 36, 48
15, 30, 45, 60
20, 40, 60, 80
25, 50, 75, 100
30, 60, 90, 120
35, 70, 105, 140
25
EPA3507-25
EPA3507G-25
40, 80, 120, 160
30
EPA3507-30
EPA3507G-30
45, 90, 135, 180
35
EPA3507-35
EPA3507G-35
50, 100, 150, 200
40
EPA3507-40
EPA3507G-40
60, 120, 180, 240
45
EPA3507-45
EPA3507G-45
70, 140, 210, 280
50
EPA3507-50
EPA3507G-50
80, 160, 240, 320
60
EPA3507-60
EPA3507G-60
84, 168, 252, 336
75
EPA3507-75
EPA3507G-75
88, 176, 264, 352
100
EPA3507-100 EPA3507G-100
90, 180, 270, 360
125
EPA3507-125 EPA3507G-125
84, 188, 282, 376
150
EPA3507-150 EPA3507G-150
100, 200, 300, 400
175
EPA3507-175 EPA3507G-175
200
EPA3507-200
225
EPA3507-225
250
EPA3507-250
300
EPA3507-300
350
EPA3507-350
400
EPA3507-400
420
EPA3507-420
440
EPA3507-440
450
EPA3507-450
470
EPA3507-470
500
EPA3507-500
†Whichever is greater. Delay measured @ 1.5V levels on leading and trailing edge w/ 15pF load on taps.
Rise and Fall Time measured from 0.75 to 2.4V level.
Electrical Characteristics
Parameter
Test Conditions
Min. Max. Unit
Schematic
SMD Part
Number
EPA3507G-200
EPA3507G-225
EPA3507G-250
EPA3507G-300
EPA3507G-350
EPA3507G-400
EPA3507G-420
EPA3507G-440
EPA3507G-450
EPA3507G-470
EPA3507G-500
VOH High-Level Output Voltage VCC = Min. VIL= Max. IOH = Max. 2.7
V
VOL Low-Level Output Voltage VCC = Min. VIH = Min. I _OL= Max.
0.5 V
VIK Input Clamp Voltage
IIH High-Level Input Current
VCC = Min. II = IIK
VCC = Max. VIN = 2.7V
-1.2 V
20 µA
IIL Low-Level Input Current VCC = Max. VIN = 0.5V
-0.6 mA
IOS Short Circuit Output Current VCC = Max. VOUT = 0.
-60 -150 mA
(One output at a time)
I _CCH High-Level Supply Current
ICCL Low-Level Supply Current
TRO Output Rise Time
VCC = Max. VIN = OPEN
VCC = Max. VIN = 0
Td ≤ 500 nS (0.75 to 2.4 Volts)
25 mA
40 mA
4 nS
Td > 500 nS
5 nS
NH Fanout High-Level Output VCC = Max. VOH = 2.7V
20 TTL LOAD
NL Fanout Low-Level Output VCC = Max. VOL = 0.5V
10 TTL LOAD
TC Temp. Coeff. of Total Delay 100 + (25000/TD) PPM/°C
TSTG Storage Temp. Range
-20 °C to +100 °C
Input Pulse Test Conditions @ 25° C
EIN
PW
TRI
PRR
VCC
Pulse Input Voltage
Pulse Width 1.2X Total Delay
Pulse Rise Time (10 - 90%)
Pulse Repetition Rate 4X PW
Supply Voltage
Unit
3.2 Volts
--- nS
3.0 nS
--- MHz
5.0 Volts
14
VCC 12 4 10 6 8 OUTPUT
INPUT 1
7 GROUND
Recommended
Operating Conditions
Min. Max. Unit
VCC Supply Voltage
VIH High-Level Input Voltage
VIL Low-Level Input Voltage
IIK Input Clamp Current
IOH High-Level Output Current
4.75 5.25 V
2.0
V
0.8 V
-18 mA
-1.0 mA
IOL Low-Level Output Current
20 mA
PW* Input Pulse Width of Total Delay 40
%
d* Duty Cycle
50 %
TA Operating Free-Air Temperature 0 +70 °C
*These two values are inter-dependent.
SMD Package
.085
Typ.
DIP Package
.200
.200
Pin 1
I.D.
PCA
EPA3507G-XX
Date Code
.270
Suggested Solder _.055
Pad Layout
Pin 1
I.D.
.420
PCA
EPA3507-XX
Date Code
.280
Max.
.300 .200
Typ. Typ.
.770
.215
.019
.100
± .002
Typ.
.300
.030
.010
± .005
0°-8°
.035
.380
.010
Typ.
.250
Max.
.300
.780 Max.
.100
.020
Min.
.020
Typ.
.125 ± .010
.010
.365
Typ.
Max.
DSA3507G-XX & DSA3507-XX Rev. - 7/22/98
Unless Otherwise Noted Dimensions in Inches
Tolerances:
Fractional = ± 1/32
.XX = ± .030 .XXX = ± .010
ELECTRONICS INC.
QAF-CSO1 Rev. B 8/25/94
16799 SCHOENBORN ST.
NORTH HILLS, CA 91343
TEL: [phone]
FAX: [phone]