EPA073HL-XX_15 Datasheet, PDF (1/1 Pages) PCA ELECTRONICS INC. – 14 Pin SMD 5 Tap Low Profile TTL Compatible Active Delay Lines

ELECTRONICS INC.
14 Pin SMD 5 Tap Low Profile TTL
Compatible Active Delay Lines
EPA073HL-XX & EPA073HL-XX-RC
Add “-RC” after part number for RoHS Compliant
PCA
Part Number
EPA073HL-25(-RC)
EPA073HL-30(-RC)
EPA073HL-35(-RC)
EPA073HL-40(-RC)
EPA073HL-45(-RC)
EPA073HL-50(-RC)
EPA073HL-60(-RC)
EPA073HL-75(-RC)
EPA073HL-100(-RC)
EPA073HL-125(-RC)
EPA073HL-150(-RC)
EPA073HL-175(-RC)
Tap Delays
(†±5% or ± 2nS)
5, 10, 15, 20
6, 12, 18, 24
7, 14, 21, 28
8, 16, 24, 32
9, 18, 27, 36
10, 20, 30, 40
12, 24, 36, 48
15, 30, 45, 60
20, 40, 60, 80
25, 50, 75, 100
30, 60, 90, 120
35, 70, 105, 140
Total Delay
(†±5% or ± 2nS)
25
30
35
40
45
50
60
75
100
125
150
175
PCA
Part Number
EPA073HL-200(-RC)
EPA073HL-225(-RC)
EPA073HL-250(-RC)
EPA073HL-300(-RC)
EPA073HL-350(-RC)
EPA073HL-400(-RC)
EPA073HL-420(-RC)
EPA073HL-440(-RC)
EPA073HL-450(-RC)
EPA073HL-470(-RC)
EPA073HL-500(-RC)
Tap Delays
(†±5% or ± 2nS)
40, 80, 120, 160
45, 90, 135, 180
50, 100, 150, 200
60, 120, 180, 240
70, 140, 210, 280
80, 160, 240, 320
84, 168, 252, 336
88, 176, 264, 352
90, 180, 270, 360
94, 188, 282, 376
100, 200, 300, 400
Total Delay
(†±5% or ± 2nS)
200
225
250
300
350
400
420
440
450
470
500
†Whichever is greater. Delay times referenced from input to leading and trailing edges at 25°C, 5.0V, with no load.
DC Electrical Characteristics
Parameter
Test Conditions
Min. Max. Unit
VOH High-Level Output Voltage VCC = min. VIL= max. IOH = max 2.7
VOL Low-Level Output Voltage VCC = min. VIH = min. IOL= max
VIK Input Clamp Voltage
IIH High-Level Input Current
VCC = min. II = II _K
VCC = max. VIN = 2.7V
VCC = max. VIN = 5.25V
IIL Low-Level Input Current
VCC = max. VIN = 0.5V
IOS Short Circuit Output Current VCC = max. V _OUT = 0.
-40
(One output at a time)
ICCH High-Level Supply Current VCC = max. VIN = OPEN
ICCL Low-Level Supply Current VCC = max. VIN = 0
TRO Output Rise Time
Td ≤ 500 nS (0.75 to 2.4 Volts)
Td > 500 nS
NH Fanout High-Level Output VCC = max. V _OH = 2.7V
NL Fanout Low-Level Output VCC = max. V _OL = 0.5V
V
0.5 V
-1.2 V
50 µA
1.0 mA
-2 mA
-100 mA
75 mA
75 mA
4 nS
5 nS
20 TTL Load
10 TTL Load
Schematic
14
VCC 12 4 10 6 8 OUTPUT
INPUT 1
7 GROUND
Package
.200
(5.08)
.055
(1.40)
Recommended Operating Conditions Min. Max. Unit
VCC
VIH
VIL
IIK
IOH
IOL
PW*
d*
Supply Voltage
High-Level Input Voltage
Low-Level Input Voltage
Input Clamp Current
High-Level Output Current
Low-Level Output Current
Pulse Width of Total Delay
Duty Cycle
4.75 5.25 V
2.0
V
0.8 V
-18 mA
-1.0 mA
20 mA
40
%
40 %
TA Operating Free-Air Temperature 0 +70 °C
*These two values are inter-dependent.
Input Pulse Test Conditions @ 25° C
EIN Pulse Input Voltage
3.2
PW Pulse Width % of Total Delay
110
TRI Pulse Rise Time (0.75 - 2.4 Volts)
2.0
PRR Pulse Repetition Rate @ Td ≤ 200 nS 1.0
Pulse Repetition Rate @ Td > 200 nS 100
VCC Supply Voltage
5.0
Unit
Volts
%
nS
MHz
KHz
Volts
.400
Max.
(10.16)
PCA
EPA073HL-XX(-RC)
Date Code
.280
Max.
(7.11)
Suggested Solder
Pad Layout
.410
(10.41)
.165 Max.
(4.19)
.300 .200
(7.62) (5.08)
.780 Max.
(19.81)
.020
(.508)
.100
(2.54)
.300
(7.62)
.010
Typ.
(.254)
.030
(.762)
.050
(1.27)
.300
(7.62)
Notes :
1. Lead Finish
2. Peak Temperature Rating
3. Moisture Sensitive Levels
4. Weight
5. Packaging Information
EPA073HL-XX EPA073HL-XX-RC
SnPb
Hot Dip Sn or SAC
225°C
245°C
3 (168 hourss,
≤30°C/60%RH)
4 (72 hours,
≤30°C/60%RH)
1.35 grams
1.35 grams
(Tube) 27 pieces/tube
27 pieces/tube
(Tape & Reel) 600 pieces/13” reel 600 pieces/13” ree
PCA ELECTRONICS, INC.
16799 SCHOENBORN ST.
NORTH HILLS, CA 91343
Unless Otherwise Specified Dimensions are in Inches /mm ± .010 /.25
Product performance is limited to specified parameters. Data is subject to change without prior notice.
CSA073HL & -RC Rev. 2 3/4/08 RR
TEL: [phone]
FAX: [phone]
http://www.pca.com